Control of fibroin conformation: Toward the development of a biomimetic spinning process for silk fibers.

摘要

Nature has shown that silks are sophisticated structural materials with remarkable mechanical properties; however, they are produced using far milder conditions than high-performance synthetic polymer fibers. While recent advances in molecular biotechnology have taken great strides toward the production of proteinaceous biopolymers, little is known about the processing conditions needed to spin fibers with the correct microstructures and mechanical properties. It is the purpose of this research to gain a fundamental understanding about how processing conditions affect the molecular structure of a model protein biopolymer, Bombyx mori silkworm fibroin, the structural protein of cocoon silk.; Fibers of B. mori fibroin were wet spun from 1,1,1,3,3,3-hexafluoro-2-propanol (HFIP) into a methanol coagulation bath. X-ray fiber diffraction and quantitative Raman spectroscopy were used to determine that both naturally- and synthetically-spun fibers contain a high degree of β-sheet (~50%). Fibers subjected to a post-spinning draw exhibited a preferential molecular alignment parallel to the fiber axis resulting in increased strength, stiffness, and extensibility. Fibers with microstructures and mechanical properties most similar to those of naturally-spun fibers were reproduced in synthetically-spun fibers with a draw ratio of 3.5. The transformation of helical fibroin in HFIP to β-sheet sheet fibroin in synthetically-spun fibers was determined to be caused by the methanol coagulation bath.; The kinetics β-sheet fibroin crystallization from aqueous solution was investigated by monitoring the sigmoidal progression of gel formation using turbidity and Raman spectroscopy. Gelation kinetics were evaluated by measuring lag time, maximum gelation rate, and optical density to determine the effects of protein concentration, detergent concentration (nucleating agent), headgroup chemistry, ionic strength, pH, and temperature. An optimal molar ratio between SDS and fibroin (100:1) was found to produce gels with minimum lag times and maximum gelation rates. Fluorescence spectroscopy and a two-step denaturation and aggregation model for gelation were used to explore the mechanism of fibroin gelation. Conditions that lead to fibroin expansion (dilute fibroin, low ionic strength, highly charged fibroin, or increased temperature) result in decreased lag times.; The results presented in this dissertation should aid in developing biomimetic spinning techniques for proteinaceous, biopolymers through the use of amphiphilic sheet nucleating agents.