首页> 外文学位 >Biomechanical comparison of locked plating and spiral blade retrograde nailing of supracondylar femur fractures.
【24h】

Biomechanical comparison of locked plating and spiral blade retrograde nailing of supracondylar femur fractures.

机译:con上股骨骨折的锁定钢板和螺旋刀逆行钉固定的生物力学比较。

获取原文
获取原文并翻译 | 示例

摘要

Background. Comminuted supracondylar femur fractures in the elderly are often treated with either retrograde femoral nailing or locked plating. Early weight-bearing is typically restricted after fixing supracondylar fractures, thereby impairing the patient's mobilization. In general, surgeons are more comfortable allowing early weight-bearing of long bone fractures after nailing rather than plating, but early studies of retrograde nails for supracondylar fractures using standard distal locking showed poor fixation compared with locked plating. Newer generation distal locking techniques, such as the spiral blade, may demonstrate improved fixation, potentially allowing early weight bearing. The purpose of this study is to biomechanically compare locked plating with retrograde nailing of osteoporotic supracondylar femur fractures with simulated physiologic weight-bearing in the post-operative period.;Methods. The Locking Condylar Plate (LCP) and Retrograde/Antegrade EX Femoral Nail (RAFN) with spiral blade locking were tested using 10 paired elderly cadaveric femurs, divided into normal and low BMD groups, with a simulated AO/OTA type 33-A3 supracondylar femur fracture. Each specimen was subjected to 200,000 loading cycles simulating six weeks of postoperative recovery with full weight-bearing for an average individual and the construct subsidence and axial stiffness were measured.;Results. LCP fixation compared to RAFN showed higher axial stiffness for normal and low BMD groups (80% and 57% respectively). After cyclic loading, axial stiffness of both constructs decreased by 20% and RAFN fixation resulted in twice as much subsidence (1.9+/-0.6 mm). Two RAFN constructs with low BMD failed after a few cycles whereas the matched pairs fixed with LCP failed after 68,000 and 100,000 cycles.;Conclusions. The LCP construct was stiffer than RAFN construct. Early weight bearing may cause 3--4 mm of subsidence in elderly patients with low BMD. However, because of the observed failures in two of the samples treated with RAFN in the low BMD group, early weight bearing is not recommended in osteoporotic bones treated with RAFN.
机译:背景。老年人粉碎性con上sup上骨折通常采用逆行股骨钉或锁定钢板治疗。固定con上骨折后,通常限制早期承重,从而损害患者的动员能力。通常,外科医生更舒适,可以在钉住后而不是在钢板上尽早对长骨骨折进行承重,但是早期对使用studies骨远端锁定的for突上骨折逆行钉的研究显示,与锁定钢板相比,固定性较差。新一代的远端锁定技术(例如螺旋刀片)可能会显示出更好的固定效果,从而有可能早日承重。这项研究的目的是在生物力学上比较术后骨质疏松性dy上股骨骨折的锁定钢板与逆行钉法的模拟生理学负重。使用10对成年BMD组和低BMD组的成年尸体进行模拟,使用模拟的AO / OTA型33-A3 con上股骨,测试了Con突锁定钢板(LCP)和带螺旋刀片锁定的逆行/整体EX股骨钉(RAFN)。断裂。对每个标本进行200,000次加载循环,模拟术后6周的恢复,平均每个人完全负重,并测量构造物的沉陷和轴向刚度。与RAFN相比,LCP固定显示正常和低BMD组的轴向刚度更高(分别为80%和57%)。循环加载后,两种结构的轴向刚度均降低了20%,而RAFN固定导致的沉降量是原来的两倍(1.9 +/- 0.6毫米)。两个具有低BMD的RAFN构造在几个循环后失败,而用LCP固定的匹配对在68,000和100,000个循环后失败。 LCP构建体比RAFN构建体更硬。早期负重可能导致低BMD的老年患者下陷3--4 mm。但是,由于在低BMD组中观察到的两个用RAFN治疗的样品均出现了故障,因此不建议在用RAFN治疗的骨质疏松性骨中早期负重。

著录项

  • 作者

    Assari, Soroush.;

  • 作者单位

    Temple University.;

  • 授予单位 Temple University.;
  • 学科 Health Sciences Surgery.;Biophysics Biomechanics.
  • 学位 M.S.M.E.
  • 年度 2012
  • 页码 29 p.
  • 总页数 29
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

  • 入库时间 2022-08-17 11:42:52

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号