首页> 外文学位 >Pressurized Low Polarity Water Extraction of Lignans, Proteins and Carbohydrates from Flaxseed Meal.
【24h】

Pressurized Low Polarity Water Extraction of Lignans, Proteins and Carbohydrates from Flaxseed Meal.

机译:从亚麻籽粕中加压低极性水提取木质素,蛋白质和碳水化合物。

获取原文
获取原文并翻译 | 示例

摘要

The physiological benefits of flaxseed against pathological disturbances, such as cancers and heart diseases, are mainly attributed to its high lignan content. This study (Experiment 1) examined the application of pressurized low polarity water (PLPW) for extraction of lignans, proteins and carbohydrates from defatted flaxseed meal. Key processing conditions included temperature (130, 160, 190°C), solvent pH (4, 6.5 and 9), solvent to solid ratio (S/S) (90, 150 and 210 mL/g) and introduction of co-packing material (0 and 3 g glass beads). The addition of 3 g glass beads as co-packing material facilitated extraction by enhancing surface contact between the liquid and solid thus shortening extraction time. Elevated temperature accelerated the extraction rate by increasing the solid diffusion coefficient thereby reducing the extraction time. The maximum yield of lignans (99 %) was obtained at temperatures ranging from 160°C to 190°C, with solvent volume of 180 mL (90 mL/g meal) at pH 9. Optimal conditions for protein extraction (70 %) were pH 9, extraction volume of 420 mL (210 mL/g meal) and 160°C. Total carbohydrates yield was maximized at 50% recovery at pH 4 and 160°C with 420 mL solvent (210 mL/g meal). Increased temperature accelerated extraction, thus reducing solvent volume and time to reach equilibrium. For the extraction of proteins, however, a temperature of 130-160°C is recommended, as proteins are vulnerable to thermal degradation due to heat decomposition.;This study also evaluated the mass transfer kinetics governing the process of lignan extraction from flaxseed meal in a fixed bed extraction cell. Diffusion of solute into the continuously flowing solvent was mainly responsible for the mass transfer mechanism as flow rate did not increase proportionally with the yield and rate of extraction. The extraction kinetics were studied on the basis of two approaches: Fick's diffusion equation and a two-site exponential kinetic model. The proposed two-site exponential kinetic model corresponding to the two-stage extraction (rapid and slow phases) successfully described the experimental data. Diffusivities attained from Fick's diffusion model ranged from 2 x 10-13 to 9 x 10-13 m2s-1 while mass transfer coefficients were between 4.5 x 10-8 and 2.3 x 10-7 ms-1 for extraction of lignans at 180°C, pH 9 with 1: 1.5 meal to co-packing material ratio.;The effects of flow rate and geometric dimensions for extraction of lignans and other flaxseed meal bioactives were further investigated in Experiment 2, based on the variables optimized in the previous experiment. Defatted flaxseed meal was extracted with pH 9 buffered water with meal to co-packing glass beads ratio of 1: 1.5 at 5.2 MPa (750 psi) and 180aC. The aqueous extracts were analyzed for lignan, protein and carbohydrate using HPLC and colorimetric methods. The optimal extraction yields for lignan, protein and carbohydrate were found at flow rates of 1 to 2 mL/min with bed depth between 20 and 26 cm and a S/S ratio of 40 to 100 mL/g. The combination of low flow rate and high bed depth allowed the use of lower S/S ratio with reduced total solvent volume consumption.
机译:亚麻籽对诸如癌症和心脏病等病理性疾病的生理益处主要归因于其高木脂素含量。这项研究(实验1)研究了加压低极性水(PLPW)在脱脂亚麻籽粕中提取木脂素,蛋白质和碳水化合物的应用。关键加工条件包括温度(130、160、190°C),溶剂pH(4、6.5和9),溶剂与固体之比(S / S)(90、150和210 mL / g)以及共装材料(0和3克玻璃珠)。添加3 g玻璃珠作为辅助包装材料,可增强液体和固体之间的表面接触,从而缩短提取时间,从而促进提取。升高温度通过增加固体扩散系数加速了萃取速率,从而减少了萃取时间。在160°C至190°C的温度下,在pH值为9的溶剂体积为180 mL(90 mL / g粗粉)下,木脂素的最大收率(99%)为70%。 pH值为9,提取量为420 mL(210 mL / g粗粉)和160°C。在pH 4和160°C下,用420 mL溶剂(210 mL / g粗粉)在50%的回收率下,总碳水化合物的收率最大。温度升高会加速萃取,从而减少溶剂量和达到平衡的时间。然而,对于蛋白质的提取,建议使用130-160°C的温度,因为蛋白质容易因热分解而热降解。;本研究还评估了控制亚麻籽粕中木脂素提取过程的传质动力学。固定床萃取池。溶质向连续流动的溶剂中扩散主要是传质机理的原因,因为流速并未随产率和萃取率成比例增加。基于两种方法研究了萃取动力学:菲克扩散方程和两点指数动力学模型。所提出的对应于两阶段提取(快速和慢相)的两点指数动力学模型成功地描述了实验数据。通过Fick扩散模型获得的扩散系数范围为2 x 10-13到9 x 10-13 m2s-1,而传质系数在4.5 x 10-8到2.3 x 10-7 ms-1之间,用于在180°C提取木脂素。 ,pH 9:1:1.5粗粉对共填充材料的比率。;在实验2中,基于先前实验中优化的变量,进一步研究了流速和几何尺寸对提取木脂素和其他亚麻籽粉生物活性物质的影响。脱脂的亚麻籽粕用pH 9缓冲水提取,粕粕与共填充玻璃珠的比例为5.2 MPa(750 psi)和180aC时为1:1.5。使用HPLC和比色法分析水提取物的木脂素,蛋白质和碳水化合物。木质素,蛋白质和碳水化合物的最佳提取产率是在流速为1至2 mL / min,床深度为20至26 cm,S / S比为40至100 mL / g的条件下找到的。低流速和高床深度的结合使得可以使用较低的S / S比,同时减少了总溶剂体积消耗。

著录项

  • 作者

    Ho, Colin Hao Lim.;

  • 作者单位

    University of Manitoba (Canada).;

  • 授予单位 University of Manitoba (Canada).;
  • 学科 Agriculture Food Science and Technology.
  • 学位 M.Sc.
  • 年度 2007
  • 页码 156 p.
  • 总页数 156
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号