ROCK MASS PROPERTIES AND HARD ROCK TBM PENETRATION RATE INVESTIGATIONS, QUEENS TUNNEL COMPLEX, NYC WATER TUNNEL #3, STAGE 2

摘要

Between 1996 and 1999, a high-performance Robbins TBM [235-282] excavated a 5 mile long, 23 ft 2 in wide, and approx 700' deep tunnel through the subsurface of southwestern Queens. Low penetration rates (approx 6'/hr [actual] vs. approx 9'/hr [anticipated]) resulted from changed rock mass conditions mostly attributable to high-grade metamorphism of the rocks. Over a three-year period, as-built circumferential geologic mapping (scale 1 in=10 ft) and digital imagery of the tunnel, fracture and fault analysis, structural, lithologic, and petrographic studies have shown that the rocks of the Queens Tunnel consist of orthogneiss of mesocratic, leucocratic, and mafic composition. These metaigneous rocks developed coarse-grained fabrics during Grenvillian (approx 1.0 Ga) granulite facies metamorphism, and retained their nearly anhydrous, poorly foliated character during subsequent high-grade Ordovician deformation. Lacking a penetrative foliation, the coarse granoblastic rock texture and extraordinary garnet content (up to 50 percent in some zones) together proved an impediment to efficient chip production and resulted in bimodal production of blocks and excessive fines. TBM excavation of the Queens Tunnel was also hindered by geological conditions that included unexpected lithology and rock fabric orientation, a zone of crosscutting hypabyssal rhyodacite dikes, and unanticipated extent of brittle faults. The dikes and brittle faults produced blocky ground conditions and a collapsing face condition that produced cutter damage and decreased utilization. Such fundamental textural, mineralogic, and lithologic control over hard-rock TBM penetration can be predicted by careful pre-bid geological analysis. To determine the causes of lower than anticipated TBM performance, a detailed investigation was carried out that included analysis of operational data from the TBM data logger and an extensive laboratory test program on cores retrieved from tunnel walls. Integrated laboratory testing included punch, point load, tensile strength, Cerchar abrasivity, and linear cutting tests, independent petrographic analysis and machine performance analysis. These allied investigations have provided quantification that the rock mass exhibited an unusually high degree of toughness and rock directional properties and established geological causes for decreased TBM penetration rates.