Research of 3D Printing Modes of Feedstock for Metal Injection Molding

摘要

In this work, to reduce the cost of production of parts using injection molding metal technology (MIM technology), it is proposed to use additive technologies (AT) for the manufacture of green parts. The use of AT allows us to abandon expensive molds and expand the field of use of the MIM of technology in single and small-scale production. For manufacture of green parts, the technology of manufacturing fused filament (Fused Filament Fabrication - FFF) is offered. The original composition of the metal powder mix (feedstock) and the filament manufacturing modes for 3D printing have been developed for the FFF technology. The cost of filament is much lower than its analogs. The factors affecting the print quality of green part are considered. All factors are divided into two groups depending on the possibility of their change during printing. The research of the influence of the coefficient filament supply on the geometry of green parts during 3D printing is presented.