首页> 外文会议>International Conference on Manufacturing Optimization, Industrial and Material Engineering >The effect of different molarities of precursor Zn(NO3)2·6H2O to the growth of ZnO by solution-immersion deposited on ZnO seeded template
【24h】

The effect of different molarities of precursor Zn(NO3)2·6H2O to the growth of ZnO by solution-immersion deposited on ZnO seeded template

机译:前体Zn(NO3)2·6H2O的不同摩尔效应通过溶液沉积在ZnO沉积在ZnO沉积物上的ZnO生长

获取原文

摘要

ZnO films were grown on glass substrates by mist-atomization, with the growth temperature of 300 °C to form ZnO seeded template. The ZnO seeded template then undergo second deposition method, which is solution-immersion method to grow ZnO on the ZnO seeded template thin film. The thin films were immersed in different molarities of starting materials; which are zinc nitrate hexahydrate and HMTA. The molarities were varied from 0.05, 0.10, 0.20 and 0.40 M. As a control to the study, the ZnO seeded template which undergoes mist-atomization only, denoted as MA only is prepared for comparison studies to the other samples. The properties of the products were examined by photoluminescence (PL) spectrophotometer, Raman spectrophotometer, and ultraviolet-visible (UV-Vis) spectrophotometer. From the PL measurement, it shows that 0.40 M sample have highest UV emission and from Raman measurements, it was found that the sample immersed in 0.40 M precursor have high crystal quality. From UV-Vis measurements, sharp UV emission at ~378 nm is observed and 0.40 M ZnO thin film shows a better absorption properties.
机译:通过雾化雾化在玻璃基材上生长ZnO薄膜,其生长温度为300℃以形成ZnO播种模板。然后ZnO播种模板进行第二沉积法,即在ZnO播种模板薄膜上生长ZnO的溶液浸渍方法。将薄膜浸入不同摩尔的起始材料;这是硝酸锌六水合物和HMTA。作为对该研究的对照,仅对研究进行对照,仅作为MA的对照,为其他样品进行比较研究,因此仅对研究进行了变化的ZnO播种模板。通过光致发光(PL)分光光度计,拉曼分光光度计和紫外 - 可见(UV-VIS)分光光度计检查产物的性质。从PL测量开始,它表明0.40M样品具有最高的UV排放和拉曼测量,发现样品浸入0.40μm前体具有高晶体质量。从UV-VI测量中,观察到〜378nm的尖锐UV发射,0.40m ZnO薄膜显示出更好的吸收性能。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号