首页> 外文会议>International Conference on Engines Vehicles >Butanol-Diesel Blend Spray Combustion Investigation by UV-Visible Flame Emission in a Prototype Single Cylinder Compression Ignition Engine
【24h】

Butanol-Diesel Blend Spray Combustion Investigation by UV-Visible Flame Emission in a Prototype Single Cylinder Compression Ignition Engine

机译:丁醇 - 柴油混合喷雾燃烧调查在原型单缸压缩点火发动机中的UV可见火焰发射

获取原文

摘要

The paper reports the results of an experimental investigation carried out in a prototype optically accessible compression ignition engine fuelled with different blends of commercial diesel and n-butanol. Thermodynamic analysis and exhaust gas measurements were supported by optical investigations performed through a wide optical access to the combustion chamber. UV-visible digital imaging and 2D chemiluminescence were applied to characterize the combustion process in terms of spatial and temporal occurrence of auto-ignition, flame propagation, soot and OH evolution. The paper illustrates the results of the spray combustion for diesel and n-butanol-diesel blends at 20% and 40% volume fraction, exploring a single and double injection strategy (pilot+main) from a common rail multi-jet injection system. Tests were performed setting a pilot+main strategy with a fixed dwell time and different starts of injection. For the diesel case, the whole amount of injected fuel and injection pressure were set at 22 mg/str and 80 MPa corresponding to a medium load regime for an automotive light duty diesel engine. The fuel amount for the butanol-diesel blends was changed to get the same chemical energy of the delivered fuel as the reference diesel case (935J/str). The investigation was carried out at two EGR rates, 0% and 50%, corresponding to a concentration of O_2 at intake of 21 and 17%, respectively. Taking advantages of the higher resistance to auto ignition of the butanol-diesel blends, the results showed a transition from the conventional to a partial premixed combustion for the BU40 in the single injection case. The combined effect of two-stage injection and EGR increased the ignition delay and the switch to the partial premixed combustion was enhanced. Improvement in NO_x-soot trade-off was obtained activating the double injection strategy particularly with the butanol blends. Optical diagnostics allowed to detect and feature the spatial distributions due to the flame luminosity and OH emission at autoignition and to estimate of the lift-off length. A high concentration of OH radicals was detected for all the test cases without EGR that corresponded to an enhanced oxidation phase and a fast soot reduction. Further, the soot oxidation phase resulted more significant for the higher butanol volume fraction in the blends.
机译:本文报告了用不同于商业柴油和正丁醇的不同共混物的原型光学可接近的压缩点火发动机中进行的实验研究结果。通过通过宽光学接入到燃烧室的光学研究支持热力学分析和废气测量。应用UV可见的数字成像和2D化学发光,以表征在自动点火,火焰繁殖,烟灰和OH进化方面的空间和时间发生方面的燃烧过程。本文说明了柴油和正丁醇 - 柴油共混物的喷雾燃烧的结果,以20%和40%的体积分数,探索来自共轨多喷射系统的单一和双注射策略(飞行员+主要)。使用固定的停留时间和不同的注射开始进行试验+主要策略进行测试。对于柴油盒,将整个注射燃料和注射压力设定为22mg / str和80MPa,对应于汽车轻型柴油发动机的介质负载制度。改变丁醇 - 柴油混合物的燃料量以使输送燃料的相同化学能作为参考柴油盒(935J / str)。调查以两个EGR速率,0%和50%进行,对应于21%和17%的摄入量的O_2浓度。采取较高抗丁醇柴油混合物的自动点火的优点,结果表明,从常规到单个喷射箱中的BU40的常规预混燃烧的过渡。两级注射和EGR的综合效果提高了点火延迟,并提高了部分预混合燃烧的开关。获得NO_X-SOOT折衷的改进是在丁醇混合物中激活双注射策略。允许光学诊断允许检测和特征在自燃的火焰亮度和孔发射,并估计剥离长度,以检测和特征。对于所有测试用例的所有测试用例,没有EGR的所有测试用例对应于增强的氧化阶段和快速烟灰降低,检测到高浓度的OH基团。此外,烟灰氧化阶段导致混合物中更高的丁醇体积分数更显着。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号