首页> 外文期刊>SAE International Journal of Engines >Butanol-Diesel Blend Spray Combustion Investigation by UV-Visible Flame Emission in a Prototype Single Cylinder Compression Ignition Engine
【24h】

Butanol-Diesel Blend Spray Combustion Investigation by UV-Visible Flame Emission in a Prototype Single Cylinder Compression Ignition Engine

机译:原型单缸压缩点火发动机中紫外可见火焰发射的丁醇-柴油共混物喷雾燃烧研究

获取原文
获取原文并翻译 | 示例
           

摘要

The paper reports the results of an experimental investigation carried out in a prototype optically accessible compression ignition engine fuelled with different blends of commercial diesel and n-butanol. Thermodynamic analysis and exhaust gas measurements were supported by optical investigations performed through a wide optical access to the combustion chamber. UV-visible digital imaging and 2D chemiluminescence were applied to characterize the combustion process in terms of spatial and temporal occurrence of auto-ignition, flame propagation, soot and OH evolution. The paper illustrates the results of the spray combustion for diesel and n-butanol-diesel blends at 20% and 40% volume fraction, exploring a single and double injection strategy (pilot+main) from a common rail multi-jet injection system. Tests were performed setting a pilot+main strategy with a fixed dwell time and different starts of injection. For the diesel case, the whole amount of injected fuel and injection pressure were set at 22 mg/str and 80 MPa corresponding to a medium load regime for an automotive light duty diesel engine. The fuel amount for the butanol-diesel blends was changed to get the same chemical energy of the delivered fuel as the reference diesel case (935J/str). The investigation was carried out at two EGR rates, 0% and 50%, corresponding to a concentration of O_2 at intake of 21 and 17%, respectively. Taking advantages of the higher resistance to auto ignition of the butanol-diesel blends, the results showed a transition from the conventional to a partial premixed combustion for the BU40 in the single injection case. The combined effect of two-stage injection and EGR increased the ignition delay and the switch to the partial premixed combustion was enhanced. Improvement in NOx-soot trade-off was obtained activating the double injection strategy particularly with the butanol blends. Optical diagnostics allowed to detect and feature the spatial distributions due to the flame luminosity and OH emission at autoignition and to estimate of the lift-off length. A high concentration of OH radicals was detected for all the test cases without EGR that corresponded to an enhanced oxidation phase and a fast soot reduction. Further, the soot oxidation phase resulted more significant for the higher butanol volume fraction in the blends.
机译:该论文报告了在原型光学可访问的压缩点火发动机中进行的实验研究结果,该发动机以商用柴油和正丁醇的不同混合物为燃料。热力学分析和废气测量得到光学研究的支持,该光学研究是通过对燃烧室的广泛光学通道进行的。紫外线可见数字成像和2D化学发光被用来根据自燃,火焰传播,烟灰和OH的时空发生来表征燃烧过程。本文阐述了以20%和40%的体积分数对柴油和正丁醇-柴油混合物进行喷雾燃烧的结果,探索了共轨多喷嘴喷射系统的单喷射和双喷射策略(先导+主喷射)。在固定的停留时间和不同的注射开始时间进行试验,以设定先导+主策略。对于柴油箱,喷射的燃油总量和喷射压力均设置为22 mg / str和80 MPa,对应于汽车轻载柴油机的中等负载状态。更改了丁醇-柴油混合物的燃料量,以使所输送燃料的化学能与参考柴油机的情况相同(935J / str)。研究是在两种EGR率(分别为0%和50%)下进行的,分别对应于进气口处O_2的浓度为21%和17%。利用丁醇-柴油共混物的较高的自燃抗性,结果表明,在单次喷射情况下,BU40从常规燃烧过渡到部分预混燃烧。两级喷射和EGR的共同作用增加了点火延迟,并增强了向部分预混燃烧的转换。尤其是使用丁醇共混物时,通过激活双喷射策略,可以改善NOx烟尘的折衷。光学诊断程序可以检测并确定由于自燃时的火焰发光度和OH排放而引起的空间分布,并估计出离长度。对于所有没有EGR的测试案例,都检测到高浓度的OH自由基,这对应于增强的氧化相和快速的烟灰还原。此外,对于共混物中较高的丁醇体积分数,烟灰氧化相导致更显着。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号