首页> 外文会议>Chinese materials congress >Desulfurization and Regeneration Performance of Sorbent Prepared by Subcritical Water Impregnation
【24h】

Desulfurization and Regeneration Performance of Sorbent Prepared by Subcritical Water Impregnation

机译:亚临界水浸渍法制备吸附剂的脱硫和再生性能

获取原文

摘要

A series of metal oxides sorbents supported on γ-Al2O3 were directly prepared by subcritical water impregnation (SCWI) method using an autoclave reactor.The effects of active components,preparation pressure,temperature,and time on the desulfurization activity of sorbents in hot coal-based gases at mid-temperature were investigated.The samples were characterized by X-ray diffraction (XRD),nitrogen adsorption and atomic absorption spectrophotometer (AAS).The results showed that Mn-based sorbent loaded on γ-Al2O3 by SCWI presented a good desulfurization performance.The optimal preparation parameters of sorbent were the temperature of 350 °C,the pressure of 18.9 MPa,impregnation time of 30 min,the precursor solution concentration of 0.287 mol/L and the volume of 100 ml,respectively.The Mn/γ-Al2O3 sorbent prepared under the optimal conditions presented a good desulfurization precision and regeneration performance.After regeneration,the mechanical strengths of the sorbents were higher than that of raw support and the breakthrough time at the desulfurization efficiency of above 99% was not obviously decreased.
机译:采用高压釜反应器,通过亚临界水浸渍(SCWI)法直接制备了一系列负载在γ-Al2O3上的金属氧化物吸附剂。活性成分,制备压力,温度和时间对热煤吸附剂脱硫活性的影响用X射线衍射(XRD),氮气吸附和原子吸收分光光度计(AAS)对样品进行了表征。结果表明,SCWI负载在γ-Al2O3上的Mn基吸附剂具有良好的吸附性能。吸附剂的最佳制备参数分别为温度350°C,压力18.9 MPa,浸渍时间30 min,前体溶液浓度0.287 mol / L,体积100 ml。在最佳条件下制备的γ-Al2O3吸附剂具有良好的脱硫精度和再生性能。再生后,吸附剂的机械强度高于t。脱硫效率达到99%以上时,原料支持率和突破时间没有明显减少。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号