首页> 外文会议> >Investigation of polycrystalline thin film CuInSe/sub 2/ cells based on ZnSe windows
【24h】

Investigation of polycrystalline thin film CuInSe/sub 2/ cells based on ZnSe windows

机译:基于ZnSe窗口的多晶薄膜CuInSe / sub 2 /电池研究

获取原文

摘要

This paper describes investigations of CIS solar cells based on ZnSe window layers deposited by MOCVD. Investigations of ZnSe/CIS solar cells are being carried out in an effort to improve the efficiencies of CIS cells and to determine if ZnSe is a viable alternative to CdS as a window material. MOCVD growth of ZnSe is accomplished in a SPIRE 500XT reactor housed in the Electronic Materials Laboratory at WSU Tri-Cities by reacting a zinc adduct with H/sub 2/Se. Conductive n-type ZnSe is grown by using iodine as a dopant. Ethyliodide was mixed with helium and installed on one of the gas lines to the system. ZnSe films have been grown on CIS substrates at 200/spl deg/C to 250/spl deg/C. ZnO is also being deposited by MOCVD by reacting tetrahydrofuran (THF) with a zinc adduct. ZnSe/CIS heterojunctions have been studied by growing n-ZnSe films onto 2 cm/spl times/2 cm CIS substrates diced from materials supplied by Siemens and then depositing an array of aluminum circular areas 2.8 mm in diameter on top of the ZnSe to serve as contacts. Al films are deposited with a thickness of 80 to 100 /spl Aring/ so that light can pass through the film, thus allowing the illuminated characteristics of the ZnSe/CIS junction to be tested. Accounting for the 20 to 25% transmittance through the Al film into the ZnSe/CIS structure, current devices have estimated, active-area AM1.5 efficiencies of 14%. Open circuit voltages <500 mV are often attained.
机译:本文介绍了基于MOCVD沉积的ZnSe窗口层的CIS太阳能电池的研究。正在进行ZnSe / CIS太阳能电池的研究,以提高CIS电池的效率,并确定ZnSe是否可作为窗玻璃材料替代CdS的可行选择。 ZnSe的MOCVD生长在WIRE Tri-Cities电子材料实验室的SPIRE 500XT反应器中完成,这是通过使锌加合物与H / sub 2 / Se反应来实现的。通过使用碘作为掺杂剂来生长导电n型ZnSe。将乙碘化物与氦气混合,并安装在通往系统的一根气体管线上。 ZnSe膜已在CIS基板上以200 / spl deg / C到250 / spl deg / C的速度生长。通过使四氢呋喃(THF)与锌加合物反应,还可以通过MOCVD沉积ZnO。 ZnSe / CIS异质结的研究是通过将n-ZnSe薄膜生长到2 cm / spl次/ 2 cm的CIS基板上,该基板由Siemens提供的材料切成小块,然后在ZnSe顶部沉积直径为2.8 mm的铝制圆形区域阵列,以供使用作为联系人。沉积厚度为80到100 / spl Aring /的Al膜,使光可以穿过该膜,从而可以测试ZnSe / CIS结的照明特性。考虑到通过Al膜进入ZnSe / CIS结构的20%到25%的透射率,目前的器件估计有源区域的AM1.5效率为14%。通常会获得<500 mV的开路电压。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号