首页> 外文会议>International Symposium on Forest Industry Wastewater; 20030602-04; Seattle,WA(US) >Evaluation of total phosphorus and total nitrogen methods in pulp mill effluents
【24h】

Evaluation of total phosphorus and total nitrogen methods in pulp mill effluents

机译:纸浆厂废水中总磷和总氮方法的评估

获取原文
获取原文并翻译 | 示例

摘要

Under the Clean Water Action Plan, the US Environmental Protection Agency is requiring states to establish numeric criteria for phosphorus and nitrogen. In preparation for the development of nutrient criteria NCASI undertook a research project to conduct a comparative study of methods for the determination of total phosphorus and total nitrogen in pulp and paper mill matrices. This paper presents results of a single laboratory method evaluation and comparative study of digestion techniques and analytical methods for the determination of total phosphorus (TP) and total nitrogen (TN) in pulp and paper mill secondary treated effluents. Analytical methods included EPA Methods 365.2 and 365.4 for TP. TN and total kjeldahl nitrogen (TKN) methods included EPA Methods 351.2, 351.4, and 353.2. Examinations of sample preservation and storage stability were conducted. Substitution of mercuric sulfate with copper sulfate during block digestion resulted in higher blank levels and method detection limits. TP measurements using EPA Method 365.4 (autoanalyzer) were found to be accurate with a positive bias as determined using matrix spike experiments. Sample digestion by acidic persulfate oxidation or mercuric sulfate block digestion in conjunction with EPA Method 365.4 yielded low blank levels (averages of 0.01 and 0.02 mg/L, respectively), precision of 2.1 and 2.4% relative standard deviations, respectively, and accuracy expressed as an average recovery (%R) of 117% for both. EPA Method 351.2 (autoanalyzer) was more precise than EPA Method 351.4 (ammonia probe). Accuracy (%R) for EPA Method 351.2 ranged from 81 to 95%, depending on the digestion technique applied, and was 55% when EPA Method 351.4 was utilized. Investigation of a method utilizing basic to acidic persulfate oxidation for the simultaneous determination of TN and TP using only two analytical techniques was found to be effective at concentrations above 1 mg/L in pulp mill effluents.
机译:根据《清洁水行动计划》,美国环境保护署要求各州建立磷和氮的数字标准。为了准备制定营养标准,NCASI进行了一项研究项目,对纸浆和造纸厂基质中总磷和总氮的测定方法进行了比较研究。本文介绍了对纸浆和造纸厂二级处理废水中总磷(TP)和总氮(TN)的测定的单一实验室方法评估结果以及消化技术和分析方法的比较研究。分析方法包括TP的EPA方法365.2和365.4。 TN和凯氏总氮(TKN)方法包括EPA方法351.2、351.4和353.2。进行样品保存和保存稳定性的检查。在块体消化过程中,用硫酸铜取代硫酸汞会导致更高的空白水平和方法检测限。发现使用EPA方法365.4(自动分析仪)进行的TP测量准确无误,如使用基质加标实验确定的正偏差。酸性过硫酸盐氧化或硫酸汞块消解与EPA方法365.4结合进行样品消解产生的空白水平低(平均分别为0.01和0.02 mg / L),相对标准偏差的精确度分别为2.1和2.4%,准确度表示为两者的平均回收率(%R)为117%。 EPA方法351.2(自动分析仪)比EPA方法351.4(氨探头)更精确。 EPA方法351.2的准确度(%R)介于81%到95%之间,具体取决于所采用的消解技术,使用EPA方法351.4时的准确度为(%R)55%。研究发现,仅使用两种分析技术,利用碱性至酸性过硫酸盐氧化方法同时测定TN和TP的方法在制浆厂废水中的浓度高于1 mg / L时是有效的。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号