Analysis of cement slurries by inductively coupled plasma optical emission spectrometry with axial viewing

摘要

The feasibility of Portland cement analysis by introduction of slurries in an inductively coupled plasma optical emission spectrometer (ICP-OES) with axial viewing has been evaluated. Afte a fast manual grinding of the cement samples, owing to the pulverized state of this material, 0.1% m/v slurries were prepared in 1% v/v HCl. The calibration was performed adopting two strategies: one based ons lurries prepared from different masses (50,75,100 and 125 mg) of a Portland cement standard reference material (NIST SRM 1881), and the other one based on aqueous reference solutions. A complete analysis of cement for major (Al, Ca, Fe, Mg and Si), mnor and trace elements (Mn, P,S,Sr and Ti) was accomplished. Both strategies led to accurate results for commercial Portland cement samples, except for si and Ti, for which the calibration with aqueous reference solutions resulted in low values. Applying a paired t-test it was shown that most results were in agreement at a 95% confidence level with a conventional fusion decompositions procedure. The ICP-OES with axial viewing and end-on gas configuration for removal of the recombination plasma zone was effective for cement slurry analysis without any undesirable particle depostion in the pre-optics interface and without severe spectral interferences.