...
首页> 外文期刊>Skeletal radiology >Comparison of fixed-flexion positioning with fluoroscopic semi-flexed positioning for quantifying radiographic joint-space width in the knee: test-retest reproducibility.
【24h】

Comparison of fixed-flexion positioning with fluoroscopic semi-flexed positioning for quantifying radiographic joint-space width in the knee: test-retest reproducibility.

机译:固定屈曲定位与荧光镜半屈曲定位的比较,用于量化膝关节X线照相术的关节间隙宽度:重测重现性。

获取原文
获取原文并翻译 | 示例
           

摘要

OBJECTIVE. To compare fixed-flexion radiography of the knee with fluoroscopic semi-flexed radiography in terms of the reproducibility of measurements of minimum joint-space width (JSW) in the medial femorotibial joint. METHODS. Posteroanterior radiographs of the right knees of 18 normal volunteers were acquired with the patients standing on an upright fluoroscopy table, the feet externally rotated 10 degrees and the toes touching the vertical table. Knees were positioned and radiographed with two different techniques: (1) semi-flexed positioning under fluoroscopic guidance using a horizontal X-ray beam; and (2) fixed-flexion positioning, with the knees and thighs touching the vertical table, using 10 degrees caudal beam angulation without fluoroscopy. Foot maps were drawn in each case. Subjects were repositioned and radiographed twice using each technique. The posteroanterior beam angle that optimally projected the medial tibia plateau with the patient in the fixed-flexion position was also determined for each subject in a separate examination using fluoroscopy. Ten patients with osteoarthritis were also examined with the fixed-flexion technique using a conventional radiographic unit. Minimum medial joint-space width (JSW) in the medial femorotibial joint was measured manually with a graduated lens and also with a semi-automated computer algorithm. RESULTS. Reproducibility errors (root-mean-square SD) for manual and automated JSW measurement were 0.2 mm and 0.1 mm, respectively, for fluoroscopic semi-flexed positioning in volunteers; 0.3 mm and 0.1 mm, respectively, for fixed-flexion positioning in volunteers; and 0.2 mm and 0.1 mm, respectively, for fixed-flexion positioning in osteoarthritic patients. The optimal beam angle for visualizing the joint space was 9.0 degrees +/-3.6 degrees. CONCLUSION. Fixed-flexion, non-fluoroscopic radiography of the knee can provide reproducible JSW measurement using widely available X-ray equipment. This technique is more feasible for multicenter clinical studies and routine clinical use than are methods that rely on fluoroscopic alignment of the tibial plateau.
机译:目的。为了比较股骨内侧关节最小关节间隙宽度(JSW)的测量结果的可重复性,比较膝关节的固定屈曲放射线照相术与透视半屈曲放射线照相术。方法。患者站在直立的荧光检查台上,脚向外旋转10度,脚尖接触垂直台,获得18名正常志愿者右膝盖的后前X线照片。用两种不同的技术对膝盖进行定位和射线照相:(1)在透视下使用水平X射线束进行半屈式定位; (2)固定屈曲定位,使膝盖和大腿接触垂直台,采用10度尾束成角度,无需透视。在每种情况下都绘制了足迹图。使用每种技术对受试者进行重新定位并进行两次射线照相。还使用荧光检查法在每个单独的检查对象中确定了每个患者在固定屈曲位置时最佳投射胫骨内侧平台的后后束角。十名骨关节炎患者也使用常规放射线照相装置通过固定屈曲技术进行了检查。股骨内侧关节的最小内侧关节间隙宽度(JSW)是通过带刻度的镜片以及半自动计算机算法手动测量的。结果。手动和自动JSW测量的可重复性误差(对于志愿者的荧光镜半弯曲定位分别为0.2毫米和0.1毫米);用于志愿者的固定屈曲定位分别为0.3 mm和0.1 mm;固定屈曲定位分别为0.2 mm和0.1 mm。用于可视化关节间隙的最佳光束角为9.0度+/- 3.6度。结论。使用广泛可用的X射线设备,膝盖的固定屈曲,非荧光透视X线照相可以提供可重复的JSW测量。该技术对于多中心临床研究和常规临床应用比依赖于荧光镜检查胫骨平台的方法更可行。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号