THE ELECTRONIC IGNITION is built on a PCB coded 05110121 and measuring 89 x 53min. This is housed in a 111 x 60 x 30mm diecast aluminium case to give a rugged assembly. Two cable glands, one at either end of the case, provide the cable entry and exit points for the power supply, coil switching and input trigger leads. The first step is to check the PCB for any defects. You then have to decide which version you are going to build. There are six different versions and it's important to choose the version that suits your car's trigger sensor. For example, if your car has a distributor with a reluctor pick-up, use the layout shown in Fig. 5. If it has a Hall Effect or Lumenition trigger, follow the layout of Fig.6.
展开▼
机译：电子点火建立在PCB编码为05110121的PCB上，尺寸为89 x 53min。它装在111 x 60 x 30mm压铸铝盒中，坚固耐用。两个电缆密封套，在外壳的两端，一个用于为电源，线圈开关和输入触发引线提供电缆入口和出口点。第一步是检查PCB是否有缺陷。然后，您必须决定要构建哪个版本。有六个不同的版本，选择适合您汽车触发传感器的版本很重要。例如，如果您的汽车有一个带有磁阻拾音器的分配器，请使用图5所示的布局。如果它具有霍尔效应或亮度触发，请遵循图6的布局。
展开▼
