首页> 外文期刊>Sensors and Actuators, A. Physical >Experimental analysis and characterization of electrostatic-drive tri-axis micro-gyroscope
【24h】

Experimental analysis and characterization of electrostatic-drive tri-axis micro-gyroscope

机译:静电驱动三轴微陀螺仪的实验分析与表征

获取原文
获取原文并翻译 | 示例
           

摘要

A planar micro-machined tri-axis gyroscope in decoupled-mode mechanical structure is presented, verified for superior detection capability and analyzed by experiments in this paper. Initially, the natural frequencies of sense modes are successfully tuned to match the natural frequency of drive mode by polarization voltages onto the associated sensing electrodes so that the inherent bias frequency at each sense mode can be removed. Secondly, the undesired cross-axis coupling effects between drive mode and sense modes are substantially suppressed by the cooperation of mechanical design and an integrated Automatic Gain Control (AGC) loop for drive mode. For highly reliable tuning to ensure resonance, the AGC and PLL (Phase Lock Loop) are integrated with a PID (Proportional, Integral and Differential) feedback controller to eliminate steady-state errors and overshoots. The performance of the micro-gyroscope is analyzed and evaluated by experiments. The achieved scale factors (the reflected voltage to the detected angular rate) of the proposed tri-axis micro-gyroscope are 50.4 mu V/degrees/s, 60.3 mu V/degrees/s, and 71.2 mu V/degrees/s for X-, Y- and Z-axes (principal axis: Z-axis) respectively. The resulted resolutions are about 0.72 degrees/s/root Hz, 143 degrees/s/root Hz and 0.42 degrees/s/root Hz for X-, Y- and Z-axes respectively. The Cross-axis sensitivities are reduced down to 22%, 9% and 1.84% for X-, Y- and Z-axes respectively. S/N ratios reach 59.3, 13.8, and 140.1 for X-, Y- and Z-axes respectively. The experimental results illustrate that the gyroscope exhibits superior to detect exerted angular rate, in addition to successful suppression upon the cross-axis perturbation between drive mode and sense mode. Principle-axis sensitivity, resolution and floor noise are all numerically evaluated. Further more, cross-axis sensitivity, Signal-to-Noise Ratio (SNR) and measurement error are investigated. Finally, a few comparisons with the other typical types of gyroscopes are reported.
机译:本文提出了一种具有解耦模式机械结构的平面微机械三轴陀螺仪,并对其进行了验证,以实现出色的检测能力,并通过实验进行了分析。最初,通过极化电压到相关的传感电极上,成功地调整了感应模式的固有频率,使其与驱动模式的固有频率匹配,从而可以消除每个感应模式下的固有偏置频率。其次,通过机械设计和用于驱动模式的集成自动增益控制(AGC)回路的配合,基本上抑制了驱动模式和感测模式之间不希望有的横轴耦合效应。为了确保调谐的高度可靠,AGC和PLL(锁相环)与PID(比例,积分和微分)反馈控制器集成在一起,以消除稳态误差和过冲。通过实验分析和评估了微型陀螺仪的性能。建议的三轴微陀螺仪实现的比例因子(反射到检测到的角速度的电压)为X的50.4μV /°/ s,60.3μV /°/ s和71.2μV /°/ s。 -,Y和Z轴(主轴:Z轴)。对于X轴,Y轴和Z轴,所得分辨率分别约为0.72度/ s /根Hz,143度/ s /根Hz和0.42度/ s /根Hz。对于X轴,Y轴和Z轴,横轴灵敏度分别降低到22%,9%和1.84%。 X,Y和Z轴的信噪比分别达到59.3、13.8和140.1。实验结果表明,陀螺仪除了能够成功抑制驱动模式和感测模式之间的横轴扰动外,还具有出色的检测角速度的能力。主轴灵敏度,分辨率和地板噪声均通过数值评估。此外,还研究了跨轴灵敏度,信噪比(SNR)和测量误差。最后,报告了与其他典型类型的陀螺仪的一些比较。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号