首页> 外文期刊>CERAMICS INTERNATIONAL >Tribological studies of monolithic chromium diboride against cemented tungsten carbide (WC-Co) under dry condition
【24h】

Tribological studies of monolithic chromium diboride against cemented tungsten carbide (WC-Co) under dry condition

机译:干燥条件下整体式二硼化铬对硬质合金碳化钨(WC-Co)的摩擦学研究

获取原文
获取原文并翻译 | 示例
           

摘要

Friction and wear behaviour of the hot pressed monolithic chromium diboride (CrB2) of 94% theoretical density were studied at different loads (3, 5 and 10 N) and frequencies (10 and 15 Hz) under dry reciprocative sliding condition against cemented tungsten carbide (WC-Co) ball. Coefficient of friction and wear rate were calculated. While the value of coefficient of friction (COF) is decreased from 0.50 to 0.36 with increasing load from 3 N to 10 N; it is observed to be nearly independent with respect to sliding frequency. The measured wear volume is in the range of 0.67x10(-3)-2.24x10(-3) mm(3) for the investigated regime. The lowest specific wear rate of 4.63 x 10(-7) mm(3)/N m was observed at 10 N load and 15 Hz frequency. Abrasive and tribo-oxidative wear with delamination were the active mechanisms manifested in both flat and counter body materials. (C) 2016 Elsevier Ltd and Techna Group S.r.l. All rights reserved.
机译:在干往复滑动条件下,在硬质合金碳化钨(3,5和10 N)和频率(10和15 Hz)下,研究了理论密度为94%的热压整体式二硼化铬(CrB2)的摩擦磨损行为。 WC-Co)球。计算了摩擦系数和磨损率。随着负载从3 N增加到10 N,摩擦系数(COF)的值从0.50减小到0.36;观察到它几乎与滑动频率无关。对于研究方案,测得的磨损量在0.67x10(-3)-2.24x10(-3)mm(3)范围内。在10 N负载和15 Hz频率下观察到的最低比磨损率为4.63 x 10(-7)mm(3)/ N m。扁平和相对主体材料均表现出磨损和摩擦氧化磨损以及分层现象。 (C)2016 Elsevier Ltd和Techna Group S.r.l.版权所有。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号