首页> 外文期刊>Regulatory Toxicology and Pharmacology: RTP >A study of airborne chrysotile concentrations associated with handling, unpacking, and repacking boxes of automobile clutch discs.
【24h】

A study of airborne chrysotile concentrations associated with handling, unpacking, and repacking boxes of automobile clutch discs.

机译:空气中温石棉浓度与汽车离合器盘的装卸,包装和重新包装相关的研究。

获取原文
获取原文并翻译 | 示例
           

摘要

Although automotive friction products (brakes and manual clutches) historically contained chrysotile asbestos, industrial hygiene surveys and epidemiologic studies of auto mechanics have consistently shown that these workers are not at an increased risk of developing asbestos-related diseases. Airborne asbestos levels during brake repair and brake parts handling have been well-characterized, but the potential exposure to airborne asbestos fibers during the handling of clutch parts has not been examined. In this study, breathing zone samples on the lapel of a volunteer worker (n=100) and area samples at bystander (n=50), remote area (n=25), and ambient (n=9) locations collected during the stacking, unpacking, and repacking of boxes of asbestos-containing clutches, and the subsequent cleanup and clothes handling, were analyzed by phase contrast microscopy (PCM) and transmission electron microscopy (TEM). In addition, fiber morphology and size distribution was evaluated using X-ray diffraction, polarized light microscopy, and ISO analytical methods. It was observed that the (1) airborne asbestos concentrations increased with the number of boxes unpacked and repacked, (2) repetitive stacking of unopened boxes of clutches resulted in higher asbestos concentrations than unpacking and repacking the boxes of clutches, (3) cleanup and clothes handling tasks yielded very low asbestos concentrations. Fiber size and morphology analyses showed that amphibole fibers were not detected in the clutches and that the vast majority (95%) of the airborne chrysotile fibers were less than 20 microm in length. Applying the ratio of asbestos fibers:total fibers (including non-asbestos) as determined by TEM to the PCM results, it was found that 30-min average airborne chrysotile concentrations (PCM adjusted) were 0.026+/-0.004 f/cc or 0.100+/-0.017 f/cc for a worker unpacking and repacking 1 or 2 boxes of clutches, respectively. The 30-min PCM adjusted average airborne asbestos concentrations at bystander locations ranged from 0.002+/-0.001 f/cc and 0.004+/-0.002 f/cc when 1 or 2 boxes of clutches were handled, respectively. Estimated 8-h TWA asbestos exposures for a worker handling 1 or 2 boxes of clutches over a workday ranged from 0.002 to 0.006 f/cc. The 30-min PCM adjusted average airborne asbestos concentration for a worker continuously stacking unopened boxes of clutches was 0.212+/-0.014 f/cc; the 8-h TWA was 0.013 f/cc. Additionally, 30-min PCM adjusted average airborne asbestos concentrations following cleanup and clothing handling were 0.002+/-0.001 f/cc and 0.002+/-0.002 f/cc, respectively, both resulting in estimated 8-h TWA asbestos exposures of 0.0001 f/cc. The results of this study indicate that the handling, unpacking, and repacking of clutches, and the subsequent cleanup and clothes handling by a worker within a short-term period or over the entire workday, result in exposures below the historical and current short-term and 8-h occupational exposure limits for asbestos.
机译:尽管历史上汽车摩擦产品(制动器和手动离合器)都含有温石棉石棉,但工业卫生调查和汽车机械师的流行病学研究始终表明,这些工人患石棉相关疾病的风险并未增加。制动器维修和制动零件处理过程中的空气中石棉含量已被很好地表征,但是未检查离合器零件处理过程中空气中石棉纤维的潜在暴露。在这项研究中,在堆叠过程中收集了志愿者工人的翻领上的呼吸区样本(n = 100)和旁观者的区域样本(n = 50),偏远地区(n = 25)和周围环境(n = 9)通过相差显微镜(PCM)和透射电子显微镜(TEM)分析了装有石棉的离合器盒的包装,开箱和重新包装,以及随后的清洁和衣物处理。此外,使用X射线衍射,偏振光显微镜和ISO分析方法评估了纤维的形态和尺寸分布。观察到,(1)空气中石棉的浓度随拆箱和重新包装的箱数的增加而增加;(2)未拆封的离合器箱的重复堆放导致石棉的浓度高于拆箱和重新包装离合器箱的石棉浓度;(3)清理和衣物处理任务产生的石棉浓度非常低。纤维尺寸和形态分析表明,在离合器中未检出角闪石纤维,绝大多数(> 95%)机载温石棉纤维的长度均小于20微米。将通过TEM确定的石棉纤维:总纤维(包括非石棉)之比应用于PCM结果,发现30分钟平均机载温石棉浓度(经PCM调节)为0.026 +/- 0.004 f / cc或0.100 +/- 0.017 f / cc,用于工人分别拆箱和拆箱1或2箱离合器。当处理一盒或两盒离合器时,旁观者位置30分钟PCM调整的平均空气传播石棉浓度范围为0.002 +/- 0.001 f / cc和0.004 +/- 0.002 f / cc。在工作日内处理1或2箱离合器的工人估计的8小时TWA石棉暴露范围为0.002至0.006 f / cc。连续堆放未打开的离合器盒的工人经过30分钟的PCM调整后的平均航空石棉浓度为0.212 +/- 0.014 f / cc; 8小时TWA为0.013 f / cc。此外,清洁和衣物处理后30分钟PCM调整后的平均空气传播石棉浓度分别为0.002 +/- 0.001 f / cc和0.002 +/- 0.002 f / cc,两者均导致估计的8小时TWA石棉暴露为0.0001 f / cc / cc。这项研究的结果表明,在短期内或在整个工作日内,工人对离合器的处理,拆包和重新包装以及随后的清理和衣服搬运工作,均导致暴露水平低于历史和当前短期水平。和8小时石棉职业接触限值。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号