...
首页> 外文期刊>Langmuir: The ACS Journal of Surfaces and Colloids >Synthesis and characterization of vinyl polymer-silica colloidal nanocomposites
【24h】

Synthesis and characterization of vinyl polymer-silica colloidal nanocomposites

机译:乙烯基聚合物-二氧化硅胶体纳米复合材料的合成与表征

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Colloidal dispersions of polymer-silica nanocomposite particles were synthesized in high yield by homopolymerizing 4-vinylpyridine (4VP) in the presence of an ultrafine silica sol using a free-radical initiator in aqueous media at 60 degrees C. Copolymerization of 4VP with methyl methacrylate and styrene also produced colloidally stable nanocomposite particles, in some cases for comonomer feeds containing as little as 6 mol % 4VP. However, homopolymerization of styrene or methyl methacrylate in the presence of the silica sol did not produce nanocomposite particles in control experiments. Thus a strong acid-base interaction between the silica sol and the (co)polymer appears to be essential for nanocomposite formation. Transmission electron microscopy studies confirmed the presence of the ultrafine silica sols within the nanocomposite particles, which typically exhibited "currant-bun" particle morphologies. This is in contrast to the "raspberry" particle morphologies previously reported for conducting polymer-silica nanocomposite particles. The average silica contents and mean particle diameters of the vinyl (co)polymer-silica nanocomposites were surprisingly insensitive to the synthesis conditions, as judged by thermogravimetric analysis and disk centrifuge photosedimentometry studies, respectively. The latter technique also indicated that some of the copolymer-silica dispersions were appreciably flocculated, although the degree of dispersion could be improved by redispersion in alkaline media. H-1 NMR spectroscopy studies on the extracted nanocomposites confirmed incorporation of the 4VP comonomer, with reasonable agreement between copolymer compositions and comonomer feeds being obtained. Aqueous electrophoresis measurements confirmed that the surface of the 4VP-silica particles is polymer-rich, which is consistent with their currant-bun morphology. Time-resolved photon correlation spectroscopy studies during nanocomposite formation showed that particle growth occurred rapidly, with particles reaching their final size after approximately 1 h. Doubling the 4VP monomer concentration at a fixed 4VP/silica ratio led to an increase in particle size from 150 to 220 nm. [References: 48]
机译:聚合物-二氧化硅纳米复合颗粒的胶体分散体是通过在自由基介质的超细二氧化硅溶胶存在下,在60°C的水性介质中,在60°C的条件下使4-乙烯基吡啶(4VP)均聚来高产率合成的。4VP与甲基丙烯酸甲酯和苯乙烯还产生了胶体稳定的纳米复合颗粒,在某些情况下,对于低至6 mol%4VP的共聚单体进料。然而,在二氧化硅溶胶存在下,苯乙烯或甲基丙烯酸甲酯的均聚在对照实验中没有产生纳米复合颗粒。因此,二氧化硅溶胶和(共)聚合物之间的强酸碱相互作用似乎对于纳米复合材料的形成是必不可少的。透射电子显微镜研究证实了在纳米复合颗粒中存在超细二氧化硅溶胶,其通常表现出“黑醋栗”的颗粒形态。这与先前报道的用于传导聚合物-二氧化硅纳米复合颗粒的“树莓”颗粒形态相反。乙烯基(共)聚合物-二氧化硅纳米复合材料的平均二氧化硅含量和平均粒径出乎意料地对合成条件不敏感,分别通过热重分析和圆盘离心光沉降法研究来判断。后一种技术还表明,尽管可以通过在碱性介质中再分散来提高分散度,但某些共聚物-二氧化硅分散体明显絮凝了。对提取的纳米复合材料的H-1 NMR光谱研究证实了4VP共聚单体的掺入,并且在共聚物组成和共聚单体进料之间获得了合理的一致性。水性电泳测量证实4VP-二氧化硅颗粒的表面富含聚合物,这与它们的醋栗孔形态一致。纳米复合材料形成过程中的时间分辨光子相关光谱研究表明,粒子生长迅速,大约1小时后粒子达到其最终尺寸。以固定的4VP /二氧化硅比将4VP单体浓度加倍导致粒径从150 nm增加到220 nm。 [参考:48]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号