首页> 外文期刊>Knee surgery, sports traumatology, arthroscopy: official journal of the ESSKA >Rotational alignment of the distal femur: anthropometric measurements with CT-based patient-specific instruments planning show high variability of the posterior condylar angle
【24h】

Rotational alignment of the distal femur: anthropometric measurements with CT-based patient-specific instruments planning show high variability of the posterior condylar angle

机译:股骨远端的旋转对准:人体测量与基于CT的患者特定器械的计划显示,con后角的变化很大

获取原文
获取原文并翻译 | 示例
       

摘要

Results: The mean (SD) PCA was 4° (1.4°) of external rotation. A significant correlation was found between more external rotation of the SEA and more proximal varus of the tibia or more distal valgus of the femur. For 59 % of the study population, 4° external rotation from the PCL would be the right amount of axial rotation to align the femoral component in line with the SEA. Nine per cent needs less, and 32 % needs more than 4° of axial rotation. On 105 (4 %) CT-based 3D models, external rotation between 7° and 11° was measured and 77 (73 %) of those cases were in varus or neutral alignment. In 132 patients, bilateral measurements were available and 94 (71 %) had rotation within 1° of the opposite side. This last finding underlines that there is even an intra-individual difference in distal femoral anatomy that can range from 1° to 5°.Purpose: Finding the anatomical landmarks used for correct femoral axial alignment can be difficult. The posterior condylar line (PCL) is probably the easiest to find during surgery. The aim of this study was to analyse whether a predetermined fixed angle referencing of the PCL could help find the surgical epicondylar axis (SEA) and this based on a large CT database with enough Caucasian diversity to be representable.Methods: A total of 2,637 CT scans and 3D reconstructions from patients on four continents, executed for preoperative planning and creation of patient-specific instrumentation, were used to perform anthropometric measurements and to measure the posterior condylar angle (PCA) between the surgical epicondylar angle and the PCL.Conclusions: This study was performed on a very large anthropometric CT and 3D models database and showed that there is a 41 % risk of malalignment if a fixed PCA referenced of the PCL is used in total knee arthroplasty. The clinical importance of this study is the observation that femoral axial anatomy is individual and also that it is determined by the tibial anatomy. A group of patients needs more than the average external rotation because they have more distal femoral valgus with dysplastic condyles or more proximal tibial varus with a bigger medial condyle.Level of evidence: III.
机译:结果:平均(SD)PCA为4度(1.4度)的外部旋转。发现SEA的更多外旋与胫骨近端内翻或股骨远端外翻之间存在显着相关性。对于59%的研究人群,从PCL向外旋转4°将是使股骨成分与SEA对齐的正确轴向旋转量。 9%的需要更少,而32%的需要超过4°的轴向旋转。在105个(4%)基于CT的3D模型上,测量到7°和11°之间的外部旋转,其中77个(73%)处于内翻或中性对齐状态。在132例患者中,可以进行双侧测量,其中94例(71%)在相对侧的1°范围内旋转。最后的发现强调,股骨远端解剖结构甚至个体内部差异可能在1°至5°之间。目的:找到用于正确进行股骨轴向对准的解剖标志可能很困难。后con突线(PCL)可能是最容易在手术期间发现的。这项研究的目的是分析PCL的预定固定角度参考是否可以帮助找到surgical上外科手术轴(SEA),并且该方法基于大型CT数据库且具有足够的白种人多样性来表示。方法:共计2637 CT对四大洲的患者进行了扫描和3D重建,以进行术前规划和创建患者专用仪器,用于进行人体测量和测量surgical上surgical角与PCL之间的con后角(PCA)。在非常大的人体测量CT和3D模型数据库上进行的一项研究表明,如果在全膝关节置换术中使用PCL的固定PCA,则存在41%的错位风险。这项研究的临床重要性在于观察到股骨轴向解剖结构是个体的,也是由胫骨解剖结构确定的。一组患者比平均外旋需要更多的东西,因为他们股骨远端远端外翻伴发育异常con或胫骨近端内翻更多伴内侧media更大。证据级别:III。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号