...
首页> 外文期刊>Medical image analysis >Geometrical analysis of registration errors in point-based rigid-body registration using invariants.
【24h】

Geometrical analysis of registration errors in point-based rigid-body registration using invariants.

机译:使用不变量基于点的刚体配准中配准误差的几何分析。

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Point-based rigid registration is the method of choice for aligning medical datasets in diagnostic and image-guided surgery systems. The most clinically relevant localization error measure is the Target Registration Error (TRE), which is the distance between the image-defined target and the corresponding target defined on another image or on the physical anatomy after registration. The TRE directly depends on the Fiducial Localization Error (FLE), which is the discrepancy between the selected and the actual (unknown) fiducial locations. Since the actual locations of targets usually cannot be measured after registration, the TRE is often estimated by the Fiducial Registration Error (FRE), which is the RMS distance between the fiducials in both datasets after registration, or with Fitzpatrick's TRE (FTRE) formula. However, low FRE-TRE and FTRE-TRE correlations have been reported in clinical practice and in theoretical studies. In this article, we show that for realistic FLE classes, the TRE and the FRE are uncorrelated, regardless of the target location and the number of fiducials and their configuration, and regardless of the FLE magnitude distribution. We use a geometrical approach and classical invariant theory to model the FLE and derive its relation to the TRE and FRE values. We show that, for these FLE classes, the FTRE and TRE are also uncorrelated. Finally, we show with simulations on clinical data that the FRE-TRE correlation is low also in the neighborhood of the FLE-FRE invariant classes. Consequently, and contrary to common practice, the FRE and FTRE may not always be used as surrogates for the TRE.
机译:基于点的刚性配准是在诊断和图像引导手术系统中对齐医疗数据集的选择方法。临床上最相关的定位误差度量是目标配准误差(TRE),它是图像定义的目标与配准后另一幅图像或物理解剖结构上定义的相应目标之间的距离。 TRE直接取决于基准定位误差(FLE),它是所选基准位置与实际(未知)基准位置之间的差异。由于通常在注册后无法测量目标的实际位置,因此通常通过基准注册误差(FRE)估算TRE,该基准误差是注册后两个数据集中基准点之间的RMS距离,或者使用Fitzpatrick的TRE(FTRE)公式进行估算。然而,在临床实践和理论研究中已经报道了低的FRE-TRE和FTRE-TRE相关性。在本文中,我们表明,对于实际的FLE类,TRE和FRE是不相关的,而与目标位置,基准点的数量及其配置以及FLE幅度分布无关。我们使用几何方法和经典不变理论对FLE进行建模,并推导其与TRE和FRE值的关系。我们表明,对于这些FLE类,FTRE和TRE也不相关。最后,我们通过对临床数据的仿真表明,在FLE-FRE不变类的附近,FRE-TRE相关性也很低。因此,与常规做法相反,FRE和FTRE可能不总是用作TRE的替代。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号