首页> 外文期刊>Macromolecules >Supercritical CO_2-Induced Stereocomplex Formation of Highly Stereoregular Isotactic Poly(methyl methacrylate) and Syndiotactic Poly(methyl methacrylate) Blends
【24h】

Supercritical CO_2-Induced Stereocomplex Formation of Highly Stereoregular Isotactic Poly(methyl methacrylate) and Syndiotactic Poly(methyl methacrylate) Blends

机译:超临界CO_2诱导的高立体球等规聚甲基丙烯酸甲酯和间规聚甲基丙烯酸甲酯共​​混物的立体复合物形成

获取原文
获取原文并翻译 | 示例
           

摘要

Crystalline stereocomplexes of highly stereoregular isotactic poly(methyl methacrylate) (it-PMMA; mm = 97.2%) and syndiotactic poly(methyl methacrylate) (st-PMMA; rr> 86.1%) blends formed by treatment with supercritical CO2 at pressures from 5 to 25 MPa and at temperatures in the 30—170 0C range were investigated by means of differential scanning calorimetry (DSC) measurements as a function of treatment temperature, pressure, and it-PMMA/st-PMMA mixing ratio. The All of the stereocomplex had a maximum at 33 wt % it-PMMA content, in agreement with stereocomplexes formed in some solvents and in bulk thermal annealing methods. For the case of over 50% it-PMMA content, two endothermic peaks, Tm’ and Tm3, were detected. Examination of the effect of heating rate from 5 to 40 0C/min on the DSC results showed that the melting temperatures, Tm’ and Tm’, corresponded to the fringed micellar structure and the lamellar crystallites of the complexed sections, respectively. For 33% or less it-P~i4IVIA content, the crystalline stereocomplex formed by supercritical CO2 had only one endothermic peak that occurred over a narrow temperature range, which was comparable with that obtained by thermal annealing or solvent treatment.
机译:高度立体规则的等规聚甲基丙烯酸甲酯(it-PMMA; mm = 97.2%)和间同立构聚甲基丙烯酸甲酯(st-PMMA; rr> 86.1%)的晶体立体复合物,是通过在5至5的压力下用超临界CO2处理而形成的通过差示扫描量热法(DSC)测量研究25 MPa的温度和30-170 0C范围内的温度与处理温度,压力及其与PMMA / st-PMMA混合比的关系。与在某些溶剂中和在本体热退火方法中形成的立体复合物一致,所有立体复合物在33重量%处的it-PMMA含量最大。对于it-PMMA含量超过50%的情况,检测到两个吸热峰Tm'和Tm3。考察5至40 0C / min的升温速率对DSC结果的影响,结果表明,熔化温度Tm’和Tm’分别对应于复杂部分的条纹胶束结构和层状微晶。当it-P〜iIVIVIA含量为33%以下时,由超临界CO2形成的晶体立体复合物只有一个吸热峰出现在狭窄的温度范围内,这与通过热退火或溶剂处理获得的吸热峰相当。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号