...
首页> 外文期刊>Green chemistry >Renewable chemical feedstocks from integrated liquefaction processing of lignocellulosic materials using microwave energy
【24h】

Renewable chemical feedstocks from integrated liquefaction processing of lignocellulosic materials using microwave energy

机译:利用微波能量对木质纤维素材料进行液化处理的可再生化学原料

获取原文
获取原文并翻译 | 示例

摘要

The objective of this investigation was to find a simple method for the production of phenolic rich products and sugar derivatives (biopolyols) via separation of liquefied lingocellulosic materials. Liquefaction of lignocellulosic materials was conducted in methanol at 180 °C for 15 min with the conversion of raw materials at about 75%. After liquefaction, the liquefied products were separated by addition of a sufficient amount of water. It was found that the hydrophobic phenolics could be largely separated from aqueous solutions. The phenolic products that precipitated from the aqueous phase were mainly composed of phenolic derivatives such as 2-methoxy-4-propyl-phenol and 4-hydroxy-3-methoxy-benzoic acid methyl ester. Afterwards, the aqueous solution was distilled under vacuum to remove water and formed a viscous liquid product henceforth termed biopolyol. As evidenced by GC-MS analysis, the biopolyols contained methyl sugar derivatives, including methyl P-D-mannofuranoside, methyl α-D-galactopyranoside, methyl α-D-glucopyranoside, and methyl P-D-glucopyranoside. The effect of glycerol on promotion of the liquefaction reaction was also studied. The yield of residue was significantly decreased from approximately 25 to 12% when a glycerol-methanol mixture was used as solvent rather than methanol. According to the GC-MS analysis, the total content of phenolics and poly-hydroxy compounds (including glycerol and sugar derivatives) in phenolic products and biopolyols was 65.9 and 84.9%, respectively. Therefore, a new method for fractionation of liquefied products was proposed according to the molecular structure of the biomass.
机译:这项研究的目的是找到一种简单的方法,通过分离液化的语言纤维素材料来生产富含酚的产品和糖衍生物(生物多元醇)。木质纤维素材料的液化在甲醇中于180°C进行15分钟,原料转化率约为75%。液化后,通过添加足够量的水分离液化产物。已经发现,疏水性酚类化合物可以从水溶液中大量分离出来。从水相中沉淀出来的酚类产物主要由酚类衍生物组成,例如2-甲氧基-4-丙基苯酚和4-羟基-3-甲氧基-苯甲酸甲酯。此后,在真空下蒸馏水溶液以除去水并形成粘性液体产物,此后称为生物多元醇。如通过GC-MS分析所证明的,生物多元醇包含甲基糖衍生物,包括甲基P-D-甘露呋喃糖苷,甲基α-D-吡喃半乳糖苷,甲基α-D-吡喃葡萄糖苷和甲基P-D-吡喃葡萄糖苷。还研究了甘油对促进液化反应的影响。当使用甘油-甲醇混合物而不是甲醇作为溶剂时,残留物的产率从约25%显着降低至12%。根据GC-MS分析,酚类产品和生物多元醇中酚类和多羟基化合物(包括甘油和糖衍生物)的总含量分别为65.9%和84.9%。因此,根据生物质的分子结构,提出了一种分离液化产物的新方法。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号