【24h】

Posterior second sacral alar iliac screw insertion: Anatomic study in a Chinese population

机译:second后第二second椎a骨螺钉插入:中国人群的解剖学研究

获取原文
获取原文并翻译 | 示例
       

摘要

Objective: To provide radiographic parameters for optimal placement of posterior second sacral alar iliac (S2AI) screw for instrumentation and fusion of scoliosis to the second sacral level in a Chinese population. Methods: S2AI screw trajectories were mapped on three-dimensional computed tomography (3DCT) reconstructions of 60 normal adult pelvises. 1 mm inferior and 1 mm lateral to the S1 dorsal foramen were chosen as the entry point, and ideal S2AI screw trajectories were explored by rotating and cutting the 3D pelvis, ensuring that the trajectories were of maximum length and width. The directions and depth of these determined trajectories were then measured. Results: The ideal S2AI screw trajectories could be found in each pelvis. The left and right screw trajectory parameters for males were shown as follows: angulation was L 29.15 ± 8.60 vs. R 29.96 ± 8.28 (p = 0.286) caudally in the sagittal plane and L 36.49 ± 3.14 vs. R 37.16 ± 3.14 (p = 0.165) laterally in the transverse plane. The maximal and intrasacral lengths of trajectory were L 121.25 ± 8.33 vs. R 120.63 ± 7.54 mm (p = 0.460) and L 26.20 ± 3.31 vs. R 26.92 ± 4.76 mm (p = 0.268). The entry point was L 28.87 ± 3.33 vs. R 29.79 ± 3.55 mm (p = 0.186) lateral to the second sacral midline, and L 44.14 ± 11.87 vs. R 43.89 ± 12.53 mm (p = 0.687) underneath the skin. The trajectories for females were more caudal (L: 34.50 ± 6.56 vs. 29.15 ± 8.60, p = 0.009; R: 35.72 ± 7.53 vs. 29.96 ± 8.28, p = 0.007) in the sagittal plane, but the lateral angulation in the transverse plane showed no difference between genders (p > 0.05). The female iliac medullar cavities were obviously narrower than those of males (L: 14.76 ± 2.46 vs. 16.98 ± 3.52, p = 0.006; R: 14.94 ± 2.60 vs. 17.00 ± 2.81, p = 0.005). Although the average maximal length of trajectories for females were about 5 mm shorter than those of males, intrasacral length were equal to those of males. Furthermore, both the distance from entry point to the S2 midline and skin in the transverse plane showed no difference between genders. Conclusion: The feasibility to insert S2AI screws to the sacrum and ilium in an Asian population along with the ideal entry angle and length of trajectory were identified for clinical practice.
机译:目的:提供放射学参数,以最佳定位第二second骨后lar骨(S2AI)螺钉,以在中国人群中将脊柱侧凸仪化和融合至第二骨水平。方法:将S2AI螺钉的轨迹绘制在60例正常成人骨盆的三维计算机断层扫描(3DCT)重建上。选择S1背孔下方1毫米和侧面1毫米作为入口点,并通过旋转和切割3D骨盆探索理想的S2AI螺钉轨迹,以确保轨迹具有最大的长度和宽度。然后测量这些确定的轨迹的方向和深度。结果:可以在每个骨盆中找到理想的S2AI螺钉轨迹。男性的左右螺钉轨迹参数如下所示:矢状面尾角的角度为L 29.15±8.60 vs. R 29.96±8.28(p = 0.286),L 36.49±3.14 vs. R 37.16±3.14(p = 0.165)在横向平面的侧面。轨迹的最大和intra内长度为L 121.25±8.33 vs. R 120.63±7.54 mm(p = 0.460)和L 26.20±3.31 vs. R 26.92±4.76 mm(p = 0.268)。进入点是第二the骨中线外侧的L 28.87±3.33 vs. R 29.79±3.55 mm(p = 0.186),皮肤下方的L 44.14±11.87 vs. R 43.89±12.53 mm(p = 0.687)。雌性的轨迹在矢状面中更像尾状(L:34.50±6.56 vs. 29.15±8.60,p = 0.009; R:35.72±7.53 vs. 29.96±8.28,p = 0.007),但横向成横向平面显示性别无差异(p> 0.05)。女性髓腔明显比男性狭窄(L:14.76±2.46 vs. 16.98±3.52,p = 0.006; R:14.94±2.60 vs. 17.00±2.81,p = 0.005)。虽然女性的平均最大轨迹长度比男性短约5 mm,但s内的长度却与男性相等。此外,从进入点到S2中线的距离以及横向平面中的皮肤均未显示性别差异。结论:确定了在亚洲人群中将S2AI螺钉插入ac骨和i骨的可行性以及理想的进入角度和轨迹长度可用于临床实践。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号