首页> 外文期刊>Investigative radiology >Seven-tesla time-of-flight angiography using a 16-channel parallel transmit system with power-constrained 3-dimensional spoke radiofrequency pulse design
【24h】

Seven-tesla time-of-flight angiography using a 16-channel parallel transmit system with power-constrained 3-dimensional spoke radiofrequency pulse design

机译:使用具有功率受限的3维辐条射频脉冲设计的16通道并行传输系统进行7特斯拉飞行时间血管造影

获取原文
获取原文并翻译 | 示例
           

摘要

OBJECTIVES: Ultrahigh magnetic fields of 7 T or higher have proven to significantly enhance the contrast in time-of-flight (TOF) imaging, one of the most commonly used non-contrast-enhanced magnetic resonance angiography techniques. Compared with lower field strength, however, the required radiofrequency (RF) power is increased at 7 T and the contrast obtained with a conventional head transmit RF coil is typically spatially heterogeneous.In this work, we addressed the contrast heterogeneity in multislab TOF acquisitions by optimizing the excitation flip angle homogeneity while constraining the RF power using 3-dimensional tailored RF pulses ("spokes") with a 16-channel parallel transmission system and a 16-channel transceiver head coil. MATERIALS AND METHODS: We investigated in simulations and in vivo experiments flip angle homogeneity and angiogram quality with a same 3-slab TOF protocol for different excitations including 1-, 2-, and 3-spoke parallel transmit RF pulses and compared the results with a circularly polarized (CP) phase setting similar to a birdcage excitation. B1 and B0 calibration maps were obtained in multiple slices, and the RF pulse for each slab was designed on the basis of 3 calibration slices located at the bottom/middle/top of each slab, respectively. By design, all excitations were computed to generate the same total RF power for the same flip angle. In 8 subjects, we quantified the excitation homogeneity and the distribution of the RF power to individual channels. In addition, we investigated the consequences of local flip angle variations at the junction between adjacent slabs as well as the impact of ΔB0 on image quality. RESULTS: The flip angle heterogeneity, expressed as the coefficient of variation, averaged over all volunteers and all slabs could be reduced from 29.4% for CP mode excitation to 14.1% for a 1-spoke excitation and to 7.3% for 2-spoke excitations. A separate detailed analysis shows only a marginal improvement for 3-spoke compared with the 2-spoke excitation. The strong improvement in flip angle homogeneity particularly impacted the junction between adjacent TOF slabs, where significant residual artifacts observed with 1-spoke excitation could be efficiently mitigated using a 2-spoke excitation with same RF power and same average flip angle. Although the total RF power is maintained at the same level than that in CP mode excitation, the energy distribution is fairly heterogeneous through the 16 transmit channels for 1- and 2-spoke excitations, with the highest energy for 1 channel being a factor of 2.4 (1 spoke) and 2.2 (2 spokes) higher than that in CP mode. In vivo experiments demonstrated the necessity for including ΔB0 spatial variations during 2-spoke RF pulse design, particularly in areas with strong local susceptibility variations such as the lower frontal lobe. CONCLUSIONS: Significant improvement in excitation fidelity leading to improved TOF contrast, particularly in the brain periphery, as well as smooth slab transitions can be achieved with 2-spoke excitation while maintaining the same excitation energy as that in CP mode. These results suggest that expanding parallel transmit methods, including the use of multidimensional spatially selective excitation, will also be very beneficial for other techniques, such as perfusion imaging.
机译:目的:已证明7 T或更高的超高磁场可以显着增强飞行时间(TOF)成像的对比度,这是最常用的非造影磁共振血管造影技术之一。然而,与较低的场强相比,所需的射频(RF)功率在7 T时会增加,并且与常规的头部发射RF线圈获得的对比度通常在空间上是异质的。在这项工作中,我们通过以下方法解决了多板TOF采集中的对比度异质性在使用16通道并行传输系统和16通道收发器磁头线圈的3维定制RF脉冲(“辐条”)来约束RF功率的同时,优化激励翻转角的均匀性。材料和方法:我们在模拟和体内实验中对相同的3-slab TOF协议进行了翻转角均一性和血管造影质量的研究,以用于不同的激发,包括1、2和3辐平行发射RF脉冲,并将结果与圆极化(CP)相位设置类似于鸟笼激励。在多个切片中获得B1和B0校准图,并分别基于位于每个平板底部/中部/顶部的3个校准切片设计每个平板的RF脉冲。通过设计,可以计算出所有激励以针对相同的翻转角生成相同的总RF功率。在8个对象中,我们量化了激励均匀性和各个通道的RF功率分布。此外,我们研究了相邻平板之间交界处局部翻转角变化的后果,以及ΔB0对图像质量的影响。结果:以变异系数表示的所有志愿者和所有平板的平均翻转角异质性可以从CP模式激励的29.4%降低到1辐激励的14.1%和2辐激励的7.3%。单独的详细分析显示,与2辐条激励相比,3辐条仅略有改善。翻转角均匀性的强力改善特别影响了相邻TOF平板之间的接合处,在这种情况下,使用具有相同RF功率和相同平均翻转角的2辐条激发可以有效地缓解使用1辐条激发所观察到的大量残留工件。尽管总的RF功率保持与CP模式激励相同的水平,但通过1和2辐激发的16个发射通道的能量分布是相当不均匀的,其中1通道的最高能量是2.4的因数(1辐条)和2.2(2辐条)高于CP模式。体内实验表明,必须在2幅RF脉冲设计期间包括ΔB0空间变化,特别是在局部磁化率变化强烈的区域(例如下额叶)中。结论:2辐激励可以在保持与CP模式相同的激励能量的同时,显着提高激励保真度,从而改善TOF对比度,尤其是在大脑周围,以及平滑的平板过渡。这些结果表明,扩展并行传输方法(包括使用多维空间选择性激发)也将对其他技术(例如灌注成像)非常有益。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号