...
首页> 外文期刊>Applied thermal engineering: Design, processes, equipment, economics >Boiling heat transfer enhancement with surfactant on the tip of a submerged hypodermic needle as nucleation site
【24h】

Boiling heat transfer enhancement with surfactant on the tip of a submerged hypodermic needle as nucleation site

机译:以水下皮下注射针的尖端为成核部位的表面活性剂增强沸腾传热

获取原文
获取原文并翻译 | 示例

摘要

The addition of small concentration surfactant additive in pure water decreases the surface tension of aqueous solution considerably, and, critical micelle concentration (cmc) decides the limit of reduction in surface tension with increasing additive concentration. The objective of the present investigation is to study bubble growth in aqueous 2-Ethyl-1-Hexanol solution, and compare it with pure water experimentally. The bubble growth was studied at 880 pmm concentration of 2-Ethyl-1-Hexanol which is critical micelle concentration (cmc). A single bubble was generated using the right angle tip of a hypodermic needle as a nucleation site. Bubble growth was studied using high speed camera operating at 1000 frames per second. The investigation was conducted at two values of heat fluxes to check the effect of heat flux on bubble growth. At low heat flux (q = 20 kW/m(2)), the bubble departure diameter was found to be almost equal for both water and aqueous surfactant solution. At high beat flux (q = 100 kW/m(2)), bubble departure diameter increases in water, but, decreases significantly in aqueous surfactant solution. The bubble release frequency was nearly equivalent for both solutions at low heat flux, but, increases for aq. surfactant solution at high heat flux, which indicates augmentation in boiling heat transfer. (C) 2016 Elsevier Ltd. All rights reserved.
机译:在纯水中添加低浓度的表面活性剂添加剂会大大降低水溶液的表面张力,并且临界胶束浓度(cmc)决定了随着添加剂浓度的增加表面张力降低的极限。本研究的目的是研究2-乙基-1-己醇水溶液中的气泡生长,并将其与纯水进行实验比较。在880 pmm的2-乙基-1-己醇浓度(临界胶束浓度(cmc))下研究了气泡的生长。使用皮下注射针头的直角尖端作为成核部位会产生单个气泡。使用以每秒1000帧的速度运行的高速相机研究了气泡的生长。在两个热通量值下进行了研究,以检查热通量对气泡生长的影响。在低热通量下(q = 20 kW / m(2)),发现水和表面活性剂水溶液的气泡离开直径几乎相等。在高节拍通量下(q = 100 kW / m(2)),水中的气泡离开直径增大,而在表面活性剂水溶液中则明显减小。在低热通量下,两种溶液的气泡释放频率几乎相等,但水溶液的气泡释放频率增加。高热通量的表面活性剂溶液,表明沸腾传热增加。 (C)2016 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号