...
首页> 外文期刊>Analytica chimica acta >Micro-volume flow titration and screening the dissociation constants (pK_a) of weak acids
【24h】

Micro-volume flow titration and screening the dissociation constants (pK_a) of weak acids

机译:微量滴定和筛选弱酸的解离常数(pK_a)

获取原文
获取原文并翻译 | 示例
           

摘要

A micro-volume, monosegmented flow analysis system has been developed for titration of weak acids and for determining dissociation constants (pKa) in the range 3-6, using pH indicators and spectroscopic detection. The system consists of a piston pump, a peristaltic pump, a detector and a 250 ILm i.d. reaction silica capillary. The analytical procedure for determining the acid concentration involves the sequential introduction of air, solutions of phenolphthalein indicator, acid sample, NaOH, and finally air again, using the piston pump. The various plugs disperse axially into each other in the reaction capillary when pumping with the peristaltic pump is started. The acid sample will then be partially neutralised and the appearance of the dramatic pH change across the combined liquid segment, bracketed by the air segments, is registered by measuring the indicator absorbance at 552 nm. In the trials reported here, the acid concentration range was 35-100 mM, the sample volume less than 1 ILl, the time needed less than 2 min, and the R.S.D. values obtained were in the range 0-2%. Two screening methods for the determination of pKa values were also developed. The first of these consumes less than 200 nl of the sample, but requires prior knowledge of the molar sample concentration. In this case, an indicator mixture, exhibiting a linear absorbance change as a function of pH at 598 nm is used instead of phenolphthalein. The second approach, used when no information about the acid concentration is available, involves both indicator solutions and is based on determining the pH at the half-neutralisation point. The sample volume needed, in this case, is less than 1 #mu#l.
机译:已经开发了一种微体积的单段流动分析系统,用于滴定弱酸并使用pH指示剂和光谱检测器测定3-6范围内的解离常数(pKa)。该系统由活塞泵,蠕动泵,检测器和250 ILm i.d组成。反应硅胶毛细管。确定酸浓度的分析程序包括依次使用活塞泵引入空气,酚酞指示剂溶液,酸样品,NaOH,最后再次引入空气。当开始使用蠕动泵泵送时,各种塞子在反应毛细管中彼此轴向分散。然后将酸样品部分中和,并通过测量552 nm的指示剂吸光度来记录整个混合液段的显着pH值变化(由空气段包围)的出现。在此处报道的试验中,酸浓度范围为35-100 mM,样品体积小于1 IL1,所需时间小于2分钟,R.S.D。获得的值在0-2%范围内。还开发了两种确定pKa值的筛选方法。这些中的第一个消耗的样品少于200 nl,但是需要先了解摩尔样品的浓度。在这种情况下,可以使用指示剂混合物代替酚酞,该指示剂混合物在598 nm处具有线性吸收率随pH值变化的特征。第二种方法在没有有关酸浓度的信息可用时使用,它涉及两种指示剂溶液,并且基于确定半中和点的pH值。在这种情况下,所需的样品量小于1#mu#l。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号