Numerical simulation of moisture-heat coupling in belt dryer and structure optimization

摘要

Highlights？We added the viscous dissipation term in the energy equation.？We used the porous medium model and the evaporation model in the calculation process.？When material thickness increases, the “ripple” phenomenon disappears.？Material thickness has the largest influence on moisture uniformity, followed by velocity.？Wing defector reduces areca-nut moisture content and improves moisture content uniformity.AbstractIn order to improve internal air flow field of belt dryer and increase moisture standard deviation of drying material in dryer, we used FLUENT software to study influences of material thickness, air velocity, air temperature and air relative humidity on material moisture content and uniformity in dryer on the basis of computational fluid mechanics and heat and mass transfer theory. Viscous dissipation was added to the energy equation. Porous medium model and evaporation model were used to improve result accuracy. A comparison between the moisture content of material inside the dryer was made when no deflector, a common deflector and a wing deflector are applied. Results show that air velocity in each measuring point is consistent with the numerical simulation. Material thickness had the largest influence on moisture content uniformity among four factors, followed by drying air velocity. The result of variance of material moisture content indicates that the thicker material thickness was, the better moisture content uniformity would be. When test conditions were shown as follows: 80mm thickness; 343K inlet air temperature; 1.5m/s air velocity; 0.24 air initial humidity, moisture standard deviation of material was optimal. The wing deflector reduced material moisture content as a whole and moisture content uniformity was improved.]]>