首页> 外文期刊>ACS applied materials & interfaces >Highly Conductive Polybenzimidazole Membranes at Low Phosphoric Acid Uptake with Excellent Fuel Cell Performances by Constructing Long-Range Continuous Proton Transport Channels Using a Metal-Organic Framework (UIO-66)
【24h】

Highly Conductive Polybenzimidazole Membranes at Low Phosphoric Acid Uptake with Excellent Fuel Cell Performances by Constructing Long-Range Continuous Proton Transport Channels Using a Metal-Organic Framework (UIO-66)

机译:通过使用金属有机框架(UIO-66)构建远程连续质子输送通道(UIO-66),具有优异的燃料电池性能的低磷酸膜的高磷酸聚苯吡喃唑膜。(UIO-66)

获取原文
获取原文并翻译 | 示例
           

摘要

Phosphoric acid (PA)-doped polybenzimidazoles generally require high PA doping levels to achieve high conductivity as high-temperature proton exchange membranes. However, high PA doping levels result in a significant decrease in the mechanical properties of and PA leaching from the membranes. Herein, a Zr-based metal-organic framework material (UIO-66) was introduced into poly[2,2'-(p-oxydiphenylene)-5,5'-benzimidazole] (OPBI) membranes. The composite membranes exhibited long-range continuous proton transport channels when the mass ratio of UIO-66 to OPBI was >= 30 wt %. The long-range continuous proton transport channels endowed the composite membranes with high proton conductivity at low PA doping levels. When the doping of UIO-66 in the OPBI membrane reached 40 wt %, the membrane exhibited the highest proton conductivity (0.092 S cm(-1), at 160 degrees C) at a low PA uptake (73.25%), while the conductivity of the pristine OPBI membrane was 0.050 S cm(-1) with a high PA uptake (217.43%). Additionally, in the oxyhydrogen fuel cell test, 40%UIO-66@OPBI membranes exhibited excellent fuel cell performance with a peak power density of 583 mW cm(-2) at 160 degrees C, which is 50% higher than that of the pristine OPBI membrane (374 mW cm(-2)). A single cell based on 40%UIO-66@OPBI also demonstrated good durability and could remain at about 600 mV after 500 h of operation under a constant load of 200 mA cm(-2).
机译:磷酸(PA) - 掺杂的聚苯和咪唑通常需要高PA掺杂水平以实现高温质子交换膜的高导电性。然而,高PA掺杂水平导致从膜的机械性能和PA浸出的显着降低。在此,将Zr基金属 - 有机骨架材料(UIO-66)引入聚[2,2' - (对二苯基)-5,5,5'-苯并咪唑](OPBI)膜中。当UIO-66至OPBI的质量比> = 30wt%时,复合膜显示出远程连续质子传输通道。远程连续质子传输通道在低PA掺杂水平下赋予具有高质子电导率的复合膜。当OPBI膜中的UIO-66掺杂达到40wt%时,膜在低PA摄取(73.25%)时显示出最高的质子电导率(0.092秒(-1),160℃),而导电性原始OPBI膜的膜为0.050 s cm(-1),高PA吸收(217.43%)。另外,在氢氧燃料电池试验中,40%UIO-66 opbi膜在160℃下表现出优异的燃料电池性能,峰值功率密度为583mm(-2),比原始的50%高50% OPBI膜(374mW cm(-2))。基于40%UIO-66 @ OPBI的单个电池也显示出良好的耐久性,并且在恒定载荷为200mA cm(-2)的恒定负荷下500小时后可以保持在约600mV。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号