...
首页> 外文期刊>Journal of Fluids Engineering: Transactions of the ASME >Three-dimensional boundary layers over an infinite swept bump and free wing
【24h】

Three-dimensional boundary layers over an infinite swept bump and free wing

机译:无限的三维边界层横扫凸起和自由翼

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Three-dimensional laminar boundary layers past an infinite swept bump and free wing were investigated numerically using the fractional step method. The objective of the work was to study the effect of surface curvature induced changes in pressuregradient and changes in the freestream flow on boundary layer skewness and growth. Simulation results demonstrate that for flows over the bump the first transition from adverse to favorable pressure gradient occurs at the front concave/convex inflexionand the second transition from favorable to adverse pressure gradient occurs at the summit. For flows past a free wing, the only transition from favorable to adverse pressure gradient occurs in front of the summit and the subsequent adverse pressuregradient is larger than the corresponding value for the bump. For both the bump and wing, the increase of initial skewing angle from 0 to 30 deg causes a 10 percent reduction in the length of the wake; the wake behind the wing is about 12 percent longerin streamwise extent than the corresponding wake behind the bump. Integral parameters in the flows over the bump display a wavy trend due to the two transitions of the pressure gradient. On the other hand, the single transition from favorable to adversepressure gradient brings about a monotonic increase of the integral parameters for flows past the wing. Near separation and reattachment, surface-streamlines are skewed strongly in the spanwise direction. Conditions of flow detachment for the bump andwing are in good agreement with correlations for laminar separating flows with power-law velocity profiles as well as correlations for wall-curvature-induced turbulent separating flows.
机译:使用分数步骤方法在数值上进行数值在数值上进行了三维层边界层过去的无限扫描凸块和自由翼。该工作的目的是研究表面曲率诱导的压力造影变化的影响,以及边界层偏振和生长的自由流动流动的变化。仿真结果表明,对于凸起上的流动,在前凹/凸拐弯距离处发生从不利地发生良好的压力梯度的转变,其第二过渡在峰会上发生不利的压力梯度。对于流过自由翼的流动,从峰会前面发生的唯一过渡率发生在峰会的前面,随后的不利压力花粉大于凸块的相应值。对于凸起和机翼,从0到30℃的初始偏斜角的增加导致唤醒长度减小10%;机翼后面的唤醒比凸块后面的相应唤醒更长度为大约12%。由于压力梯度的两个过渡,凸块上的流量的积分参数显示波动趋势。另一方面,从有利于普通的渐变梯度的单个过渡带来了通过机翼流过流量的整体参数的单调增加。近分离和重新连接,表面流线型在枝条方向上强烈偏斜。凸块和翼型的流动拆卸条件与具有电力法速度分布的层状流量的相关性以及用于壁曲率诱导的湍流分离流的相关性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号