Machining Performance Characteristics of Inconel 718 Superalloy Due to Hole-Sinking Ultrasonic Assisted Micro-EDM

摘要

Inconel 718 superalloy is widely used in aerospace industries for fabrication of the various components for aircraft engine because of its high strength at elevated temperature. It is an extremely difficult-to-machine material due to its work hardening nature and poor thermal conductivity. Creating micro-holes of high precision in this material is beyond the capability of conventional twist drill due to its low thermal conductivity. Micro-electrical discharge machining (micro-EDM) is a well-established process for the machining of any electrically conductive hard and brittle material, but due to very small feature size and narrow discharge gap, removal of debris becomes difficult, causes arcing and short-circuiting. In order to solve this problem, authors indigenously developed an innovative ultrasonic-assisted micro-EDM setup for workpiece vibration. The machining performance characteristics of Inconel 718 superalloy was studied using the developed setup in sinking configuration in terms of material removal rate (MRR), tool wear rate (TWR) and hole taper (Ta) considering the effect of ultrasonic power, gap current, pulse on time and pulse off time. It was observed that higher ultrasonic power was more suitable for higher MRR, lower TWR and Ta. It was also found from the results that 3 A gap current at 6μs pulse on time was appropriate for better MRR and 12μs pulse on time was more appropriate for low TWR and Ta. The scanning electron microscope (SEM) analysis of created micro-holes was also performed with and without ultrasonic vibration to ensure the quality as well as accuracy.