首页> 外文期刊>Aerosol Science and Technology: The Journal of the American Association for Aerosol Research >Structural Properties of Diesel Exhaust Particles Measured by Transmission Electron Microscopy (TEM): Relationships to Particle Mass and Mobility
【24h】

Structural Properties of Diesel Exhaust Particles Measured by Transmission Electron Microscopy (TEM): Relationships to Particle Mass and Mobility

机译:透射电子显微镜(TEM)测量的柴油机排气颗粒的结构性质:与颗粒质量和迁移率的关系

获取原文
获取原文并翻译 | 示例
           

摘要

Structural properties of diesel particles preclassifled by particle mobility and mass are measured using transmission electron microscopy (TEM).These measurements enable us to determine the dynamic shape factor and inherent material density of diesel particles.We also compare fractal dimensions obtained independently using two different approaches. We show that the projected area equivalent diameter of mobility-classified diesel particles nearly equals the mobility diameter in the size range reported here (50 to 220 nm).Evidence for doubly charged particles and possible "fragments" are observed for DMA-classified particles on TEM substrates.The fractal dimension was obtained using two independent approaches.Images obtained by TEM were analyzed to determine the maximum length and the number of primary particles.The fractal dimension obtained from these measurements,D_(fL),was 1.75.The fractal dimension obtained from the mass-mobility relationship,D_(fm),was 2.35.We found that these values are in reasonable agreement after accounting for the relationship between the projected area diameter and maximum length.The size-dependent dynamic shape factor and inherent material density of diesel particles are obtained from independent measurements of mobility (DMA),mass (APM),and volume (TEM).We found that the dynamic shape factor increased from 1.11 to 2.21,and that the inherent material density increased from 1.27 to 1.78 g/cm~3 as particle mobility size increased from 50 to 220 nm.The increase in dynamic shape factor with size occurs because large particles are more irregular than smaller ones.The increase in density occurs because the ratio of elemental carbon to condensed organics increases with increasing size.
机译:通过透射电子显微镜(TEM)测量了按颗粒迁移率和质量预分类的柴油颗粒的结构特性,这些测量值使我们能够确定柴油颗粒的动态形状因数和固有材料密度,还比较了使用两种不同方法独立获得的分形维数。我们显示出,在此报告的粒径范围(50至220 nm)中,迁移率分类的柴油颗粒的投影面积当量直径几乎等于迁移率直径。在DMA分离的颗粒上观察到了双电荷颗粒和可能的“碎片”的证据。 TEM衬底的分形维数是通过两种独立的方法获得的,分析通过TEM获得的图像以确定最大长度和一次粒子的数量。从这些测量值获得的分形维数D_(fL)为1.75。从质量迁移率关系D_(fm)得到的值为2.35,在考虑了投影面积直径和最大长度之间的关系后,我们发现这些值在合理范围内。尺寸相关的动态形状因子与固有材料密度通过独立测量迁移率(DMA),质量(APM)和体积(TEM)获得柴油颗粒的数量。我们发现动态形状因子增加了从1.11到2.21,并且随着粒子迁移率尺寸从50 nm增加到220 nm,固有材料密度从1.27增至1.78 g / cm〜3。动态形状因子随尺寸增加是因为大粒子比小粒子更不规则密度增加是因为元素碳与缩合有机物的比例随尺寸增加而增加。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号