...
首页> 外文期刊>Minerals Engineering >Adsorption of hydrophobically modified polyacrylamide P(AM-NaAA-C(16)DMAAC) on model coal and clay surfaces and the effect on selective flocculation of fine coal
【24h】

Adsorption of hydrophobically modified polyacrylamide P(AM-NaAA-C(16)DMAAC) on model coal and clay surfaces and the effect on selective flocculation of fine coal

机译:疏水改性聚丙烯酰胺P(AM-NaAA-C(16)DMAAc)对模型煤和粘土表面的吸附及对细煤选择性絮凝的影响

获取原文
获取原文并翻译 | 示例
           

摘要

Selective flocculation separation has been widely used in fine coal flocculation. In order to promote the adsorption selectivity of flocculants onto coal surface, hydrophobically modified polyacrylamide P(AM-NaAA-C(16)DMAAC) was synthesized. The adsorption of P(AM-NaAA-C(16)DMAAC) on model day and coal surfaces (i.e., silica, alumina and asphaltene surfaces) was investigated using quartz crystal microbalance with dissipation (QCM-D) monitoring technique. Floc size distribution, Fourier transform infrared spectrum, zeta potential measurement and selective flocculation flotation test were also conducted to study the performance of P(AM-NaAA-C(16)DMAAC) in the separation of fine coal. QCM-D measurements showed that a thin and rigid adsorption layer was formed on silica and alumina surfaces after injecting 1 mM sodium hexapolyphosphate (Calgon). This pre-formed layer inhibited the further adsorption of P(AM-NaAA-C(16)DMAAC) on silica and alumina. Meanwhile, the asphaltene surface could not be passivated by calgon due to the weak and reversible adsorption. Thus, a significant amount of P(AM-NaAA-C(16)DMAAC) (20 mg/L) absorbed on the calgon-treated asphaltene surface in 100 mM KCl solution was detected. With 20 mg/L P(AM-NaAA-C(16)DMAAC) in 100 mM KCl and 1 mM calgon solution, the maximum diameters of 10%, 50% and 90% of the cumulative volume distributions of the floc, i.e., d(10) (20.29 mu m), d(50) (45.55 mu m) and d(90) (89.99 mu m) of the coal floc were 7.42, 3.20 and 2.19 times of those of kaolinite floc, respectively. Clean coal with a combustible recovery of 80.87% and ash content of 9.78% was obtained at a dosage of 5 g/t of P(AM-NaAA-C(16)DMAAC) and 900 g/t kerosene. Experimental results demonstrated that selective flocculation flotation with P(AM-NaAA-C(16)DMAAC) could enhance the recovery of fine coal particles with a lower dosage of collector. Our work sheds lights on the fundamental and practical understanding of the hydrophobic interactions in the selective flocculation of coal in the industries, and rational development of flocculants with better selectivity and flocculation efficiency.
机译:选择性絮凝分离已广泛用于细煤絮凝。为了将絮凝剂的吸附选择性促进到煤表面上,合成了疏水性改性的聚丙烯酰胺P(AM-NaA-C(16)DMAAc)。使用石英晶体微稳定进行耗散(QCM-D)监测技术,研究了对模型日和煤表面(即二氧化硅,氧化铝和沥青质表面)进行模型日和煤表面的吸附(即二氧化硅,氧化铝和沥青质表面)。还进行了Floc尺寸分布,傅里叶变换红外光谱,Zeta电位测量和选择性絮凝浮选测试,以研究P(AM-NaA-C(16)DMAAc)在细煤的分离中的性能。 QCM-D测量表明,在注射1mM六氢磷酸钠(Calgon)之后,在二氧化硅和氧化铝表面上形成薄且刚性的吸附层。该预形成层抑制了在二氧化硅和氧化铝上的P(AM-NaA-C(16)DMAAc)的进一步吸附。同时,由于弱和可逆的吸附,沥青质表面无法被卡格森钝化。因此,检测到在100mM KCl溶液中吸收的大量P(AM-NaA-C(16)DMAAc)(20mg / L)吸收在克朗处理的沥青质表面上。在100 mm KCl和1mm Calgon溶液中,含有20mg / LP(AM-NaAA-C(16)DMAAc),最大直径为絮凝物的累积量分布的10%,50%和90%,即D. (10)(20.29μm),d(50)(45.55μm)和d(90)(89.99μm)分别为高岭石絮凝物的7.42,3.20和2.19倍。清洁煤具有80.87%的可燃煤,在5g / t的P(AM-NaA-C(16)DMAAc)和900g / T煤油的剂量的剂量下获得9.78%的灰分含量为9.78%。实验结果表明,具有P的选择性絮凝浮选(AM-NaA-C(16)DMAAc)可以增强具有较低剂量的细煤颗粒的回收率。我们的工作揭示了对煤炭在工业中煤的选择性絮凝中的疏水性互动的基本和实践的灯光,以及具有更好的选择性和絮凝效率的絮凝剂的理性发育。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号