首页> 外文期刊>Microsystem technologies >A low power fully differential RF receiver front-end for 2.4GHz wireless sensor networks
【24h】

A low power fully differential RF receiver front-end for 2.4GHz wireless sensor networks

机译:低功耗全差分RF接收器前端为2.4GHz无线传感器网络

获取原文
获取原文并翻译 | 示例
           

摘要

In this paper, a novel merged LNA-mixer denoted as LNMA is proposed. The proposed LNMA consisting of a folded cascode LNA using improved derivative superposition technique and folded double-balanced subthreshold mixer using capacitor cross-coupled common-gate transconductor and it is integrated with on-chip LC voltage controlled oscillator (LC-VCO). In LNMA, a diode and power clamp based on-chip ESD protection circuit is used to tolerate ESD current of human-body-model specifications. To evaluate its performance, it is implemented in 0.18-mu m MMRF CMOS process with 1-V supply, studied through post layout simulation and compared the results with other reported works. It achieves higher conversion gain of 27dB, lower noise figure of 9.5dB, lower input return loss (S11) of -20dB, higher third-order input intercept point (IIP3) of -16dBm and higher IIP2 of +29.9dBm compared to the works reported in the literature. The on-chip oscillator has the lower phase noise of -114dBc/Hz. The proposed LNMA and the LC-VCO achieves the power consumptions of 1.6 and 1.72mW, respectively at 1-V power supply.
机译:本文提出了一种新的合并LNA混合器,其表示为LNMA。所提出的LNMA由使用电容器交叉耦合公共栅极跨电导体的折叠式Cascode LNA组成,使用改进的衍生物叠加技术和折叠的双平衡亚阈值混频器,并与片上LC电压控制振荡器(LC-VCO)集成。在LNMA中,基于二极管和电力钳位的片上ESD保护电路用于容忍人体模型规格的ESD电流。为了评估其性能,它在0.18-mu M mmrf CMOS工艺中实现,通过1-V电源进行,通过布局后模拟研究,并将结果与​​其他报告的作品进行比较。它达到更高的转换增益27dB,较低的噪声系数为9.5dB,较低的输入回波损耗(S11)-20dB,较高的三阶输入截取点(IIP3)的-16dBm和较高的IIP2 + 29.9dBm的IIP2相比在文献中报道。片上振荡器具有-114dBc / hz的较低相位噪声。所提出的LNMA和LC-VCO分别以1-V电源实现1.6和1.72mW的功耗。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号