Shear tests of interfaces between calcareous sand and steel

摘要

Various modified direct shear tests on the interface between calcareous sand and steel with different degrees of roughness were conducted in this article, and the different interface property results between calcareous sand-steel and siliceous sand-steel were compared. It was found that: (1) Under various normal stresses, the limit shear stress at the interface reaches the peak value when the groove depth is at the critical value Rcr. Further, when the flat width is at a critical value Gcr, the limit interface shear stress reaches to that of a grooved surface with a flat width of zero. (2) The magnitudes of Rcr and Gcr are related to the gradation and grain size of sand. For the calcareous sand tested, Rcr and Gcr are three times and seven times the mean grain size, respectively. (3) When the intersection angle between the symmetrical V-shaped grooves and the direct shear direction equals to 45?, the limit interface shear stress reaches the peak value and no significant increase is observed at the larger intersection angle. (4) Under the same interface testing conditions with siliceous and calcareous sands, the interface friction angle of the calcareous sand is ?5??6? greater than that of siliceous sand.