首页> 外文期刊>Crystal growth & design >Formation and growth of structure-H hydrate crystals on a water droplet in contact with methane gas and a large-molecule guest substance liquid
【24h】

Formation and growth of structure-H hydrate crystals on a water droplet in contact with methane gas and a large-molecule guest substance liquid

机译:与甲烷气体和大分子客体液体接触的水滴上结构H水合物晶体的形成和生长

获取原文
获取原文并翻译 | 示例
           

摘要

This paper reports on our visual observations of the formation and growth of structure-H hydrate crystals on a water drop partially exposed to methane gas and partially immersed in a pool of a liquid large-molecule guest substance (LMGS) for a structure-H hydrate. In each experiment, 2,2-dimethyl butane (neohexane), methylcyclohexane, or tert-butyl methyl ether was used as an LMGS with methane as a small-molecule guest substance. The temperature and pressure of the test section were set at 273.5 +/- 0.2 K and 2.5 +/- 0.06 MPa, respectively, to avoid possible structure-I methane hydrate formation, which may occur at a pressure above 2.7 MPa at this temperature. Hydrate crystals first formed on the water drop surface and then floated up to the apex of the drop. The hydrate crystals that were thus accumulated on the apex of the drop grew to form a cap or shell that partially covered the upper area of the drop surface. This hydrate crystal shell exhibited a coarse, apparently polycrystalline, surface texture. The polycrystalline hydrate crystals continued to grow while maintaining the form of a shell intervening between the liquid water and the methane gas. These crystals eventually covered the entire upper area of the water drop surface exposed to methane gas. This hydrate crystal growth process was commonly observed with all three of the LMGSs tested in this study. No preferential growth of the hydrate crystals on the methane-water-LMGS three-phase interfacial line, where the three substances necessary for structure-H hydrate formation are in mutual contact, was observed in any experimental run.
机译:本文报告了我们在部分暴露于甲烷气体并部分浸入液态大分子客体物质(LMGS)的H型水合物中的水滴上形成H型水合物晶体的视觉观察结果。在每个实验中,使用2,2-二甲基丁烷(正己烷),甲基环己烷或叔丁基甲基醚作为LMGS,其中甲烷为小分子客体。将测试部分的温度和压力分别设置为273.5 +/- 0.2K和2.5 +/- 0.06MPa,以避免可能的结构I甲烷水合物的形成,其可能在该温度下在高于2.7MPa的压力下发生。水合物晶体首先在水滴表面形成,然后漂浮到水滴的顶点。因此,聚集在液滴顶部的水合物晶体长大,形成了覆盖了液滴表面上部区域的盖或壳。该水合物晶体壳表现出粗糙的,显然多晶的表面纹理。多晶水合物晶体继续生长,同时保持了介于液态水和甲烷气体之间的壳形。这些晶体最终覆盖了暴露于甲烷气体的水滴表面的整个上部区域。在本研究中测试的所有三种LMGS中,普遍观察到这种水合物晶体的生长过程。在任何实验运行中,均未观察到甲烷-水-LMGS三相界面线上的水合物晶体优先生长,其中结构H水合物形成所需的三种物质相互接触。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号