...
首页> 外文期刊>Biosystems Engineering >Moisture Sorption Behaviour and Thermodynamic Characteristics of Rice stored in a Chamber under Controlled Humidity
【24h】

Moisture Sorption Behaviour and Thermodynamic Characteristics of Rice stored in a Chamber under Controlled Humidity

机译:湿度控制下储藏室中水稻的水分吸附行为和热力学特征

获取原文
获取原文并翻译 | 示例
           

摘要

The moisture sorption isotherms of rice stored in a chamber, the relative humidity of which is controlled by an atomising humidification system were determined at 25, 35 and 45℃ and within the range of 0.1-0.9 water activity. The sorption isotherm curves of rice showed the characteristics of a type II isotherm. The equilibrium moisture content increased with a decrease in storage temperature at any given water activity. The sorption isotherms exhibited hysteresis over the whole water activity range. The mathematical description of the sorption data was obtained applying some of the most common sorption equations [Guggenheim-Anderson-de Boer (GAB), Brunauer-Emmett-Teller (BET), Henderson, Iglesias and Chirife, Oswin, Peleg, Smith and Caurie equations]. A non-linear regression analysis was used to evaluate the constants of the sorption equations. Among the various models tested to interpret sorption isotherms, the model having best statistical indicators was selected as the most appropriate model. The Peleg model gave the best fit to the experimental sorption data over the range of temperatures and water activity investigated. The agreement between experimental and predicted values of the Peleg model was found to be satisfactory. In the range of water activity 0-0.4, the BET model was shown to give the closest fit to the experimental data. The surface area of monolayer was calculated and the water activities corresponding to the monolayer values were determined. Sorption isotherm data were used to determine the thermodynamic functions such as isosteric heat of sorption, sorption entropy, spreading pressure, net integral enthalpy and entropy. The isosteric heats of sorption were determined from the best-fitting equation using the Clasius-Clapeyron equation. Isosteric heat decreased with increase in moisture content and approached the latent heat of vaporisation of pure water at moisture contents above 0.2 kg [water] kg{sup}(-1) [dry solids]. The spreading pressures increased with increasing water activity. Within the moisture range of 0.013-0.207 kg [water] kg{sup}(-1) [dry solids], the net integral enthalpy decreased with increase in moisture content and net integral entropy increased with increase in moisture content. Net integral entropy was negative in value.
机译:储存在室内的大米的水分吸收等温线是通过雾化加湿系统控制的,其相对湿度分别在25、35和45℃下测定,水分活度在0.1-0.9范围内。水稻的吸附等温线曲线表现出II型等温线的特征。在任何给定的水分活度下,平衡水分含量都随着储存温度的降低而增加。吸附等温线在整个水分活度范围内都显示出滞后现象。吸附数据的数学描述是使用一些最常见的吸附方程式获得的[古根海姆-安德森-德布尔(GAB),布鲁瑙尔-埃米特-泰勒(BET),亨德森,伊格莱西亚斯和基里夫,奥斯温,佩勒格,史密斯和考里方程]。非线性回归分析用于评估吸附方程的常数。在为解释吸附等温线而测试的各种模型中,具有最佳统计指标的模型被选为最合适的模型。 Peleg模型在所研究的温度和水活度范围内最适合实验吸附数据。发现Peleg模型的实验值和预测值之间的一致性是令人满意的。在水活度为0-0.4的范围内,BET模型显示出与实验数据最接近的拟合。计算单层的表面积,并确定与单层值相对应的水活度。吸附等温线数据用于确定热力学函数,如等温吸附热,吸附熵,扩散压力,净积分焓和熵。使用Clasius-Clapeyron方程根据最佳拟合方程确定吸附的等排热。当水分含量超过0.2 kg [水] kg {sup}(-1)[干燥固体]时,等热量随着水分含量的增加而降低,并接近纯水的蒸发潜热。扩散压力随着水分活度的增加而增加。在水分含量为0.013-0.207 kg [水] kg {sup}(-1)[干燥固体]的范围内,净积分焓随水分含量的增加而降低,净积分熵随水分含量的增加而增加。净积分熵为负值。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号