首页> 外文期刊>Contributions to Plasma Physics >Protons and carbon ions acceleration in the target-normal-sheath-acceleration regime using low-contrast fs laser and metal-graphene targets
【24h】

Protons and carbon ions acceleration in the target-normal-sheath-acceleration regime using low-contrast fs laser and metal-graphene targets

机译:使用低对比度FS激光和金属 - 石墨烯靶标在目标正常鞘加速度下的质子和碳离子加速

获取原文
获取原文并翻译 | 示例
           

摘要

fs pulsed lasers at an intensity of the order of 10(18) W/cm(2), with a contrast of 10(-5), were employed to irradiate thin foils to study the target-normal-sheath-acceleration (TNSA) regime. The forward ion acceleration was investigated using 1/11 mu m thickness foils composed of a metallic sheet on which a thin reduced graphene oxide film with 10 nm thickness was deposited by single or both faces. The forward-accelerated ions were detected using SiC semiconductors connected in time-of-flight configuration. The use of intense and long pre-pulse generating the low contrast does not permit to accelerate protons above 1 MeV because it produces a pre-plasma destroying the foil, and the successive main laser pulse interacts with the expanding plasma and not with the overdense solid surface. Experimental results demonstrated that the maximum proton energies of about 700 keV and of 4.2 MeV carbon ions and higher were obtained under the condition of the optimal acceleration procedure. The measurements of ion energy and charge states confirm that the acceleration per charge state is measurable from the proton energy, confirming the Coulomb-Boltzmann-shifted theoretical model. However, heavy ions cannot be accelerated due to their mass and low velocity, which does not permit them to be subjected to the fast and high developed electric field driving the light-ion acceleration. The ion acceleration can be optimized based on the laser focal positioning and on the foil thickness, composition, and structure, as it will be presented and discussed.
机译:FS脉冲激光在10(18)厘米(2)的阶数,其对比度为10(-5),用于照射薄箔以研究靶普通鞘加速度(TNSA)政权。研究了由由金属片组成的1/11μm厚的箔进行研究,其中通过单个或两个面沉积具有10nm厚度的薄的氧化石墨烯氧化物膜。使用在飞行时间内连接的SiC半导体检测前速加速离子。使用强烈和长脉冲产生低对比度不允许加速1 meV以上的质子,因为它产生了箔的预浆,并且连续的主激光脉冲与膨胀等离子体相互作用,而不是用过阵的固体相互作用表面。实验结果表明,在最佳加速度过程的条件下,获得了约700keV和4.2meV碳离子的最大质子能量。离子能量和电荷状态的测量确认每个充电状态的加速度可从质子能量测量,确认库仑-Boltzmann转移理论模型。然而,由于其质量和低速而不能加速重离子,这不允许它们经受快速和高发达的电场驱动光离子加速度。离子加速度可以基于激光焦点定位和箔厚度,组成和结构优化,因为它将被呈现和讨论。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号