首页> 外文期刊>Acta odontologica Scandinavica. >Effect of bleaching agents and whitening dentifrices on the surface roughness of human teeth enamel
【24h】

Effect of bleaching agents and whitening dentifrices on the surface roughness of human teeth enamel

机译:漂白剂和增白剂对人牙釉质表面粗糙度的影响

获取原文
获取原文并翻译 | 示例
           

摘要

Objective. The aim of this in vitro study was to evaluate the surface roughness of human enamel bleached with 10% carbamide peroxide or 10% hydrogen peroxide bleaching agents at different times and also subjected to different superficial cleaning treatments. Materials and methods. One hundred and forty flat enamel samples were divided into 14 groups, Group 1-Group 14 (G1-G14). G1-G7 were treated with 10% carbamide peroxide and different dentifrices, G8-G14 were treated with 10% hydrogen peroxide and different dentifrices (Gl and G8: not brushed as control groups; G2 and G9: brushed with Ipana~R toothpaste; G3 and G10: brushed with Clinomyn~R toothpaste; G4 and Gil: brushed with Moos Dent~R toothpaste; G5 and G12: brushed with Signal~R toothpaste; G6 and G13: brushed with Colgate~R toothpaste; G7 and G14: brushed without dentifrice). A profilometer was used to measure average roughness values of the initial surface roughness and at each 7-day-interval. The bleaching was performed for 6 h a day and the surface cleaning treatment was performed 3-times a day, 2 min each time, for 4 weeks. The samples were stored in distilled water during the test period. Results. Statistical analysis revealed significant differences in surface roughness values over time for all groups except Gl and G8 (not brushed). The results of the surface roughness of all groups were nearly the same. Conclusions. The bleaching with 10% hydrogen peroxide and 10% carbamide peroxide did not alter the enamel surface roughness, but when the bleaching treatment was performed combined with abrasive dentifrices, a significant increase in roughness values was observed.
机译:目的。这项体外研究的目的是评估在不同时间用10%过氧化脲或10%过氧化氢漂白剂漂白的人类牙釉质的表面粗糙度,并对其进行不同的表面清洁处理。材料和方法。一百四十个平面搪瓷样品分为14组,第1组至第14组(G1-G14)。 G1-G7用10%过氧化脲和不同的牙粉处理,G8-G14用10%过氧化氢和不同的牙粉处理(G1和G8:未刷牙作为对照组; G2和G9:用Ipana〜R牙膏刷牙; G3 G10:用Clinomyn〜R牙膏刷; G4和Gil:用Moos Dent〜R牙膏刷; G5和G12:用Signal〜R牙膏刷; G6和G13:用Colgate〜R牙膏刷; G7和G14:不刷牙洁牙剂)。使用轮廓仪来测量初始表面粗糙度的平均粗糙度值,并且每隔7天间隔一次。每天进行6小时漂白,每天进行3次表面清洁处理,每次2分钟,持续4周。在测试期间,将样品存储在蒸馏水中。结果。统计分析表明,除G1和G8(未刷涂)外,所有组的表面粗糙度值均随时间变化显着。所有组的表面粗糙度结果几乎相同。结论用10%的过氧化氢和10%的过氧化脲进行漂白不会改变搪瓷的表面粗糙度,但是当与磨牙剂一起进行漂白处理时,观察到粗糙度值明显增加。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号