An experimental investigation on the deformation and post-formed strength of heat-treatable aluminium alloys using different elevated temperature forming processes

摘要

Forming at elevated temperatures can significantly increase the ductility of aluminium alloys enabling the manufacture of complex-shaped panel components from sheets. This study describes and investigates two elevated temperature forming processes: Hot Form Quench (HFQ (R)) (Lin et al., 2008) and conventional hot forming (HF) of aluminium alloys, with various material condition and processing parameters in order to advance the understanding of forming characteristics and post-formed strength. High temperature uniaxial tensile tests of AA7075 under HFQ (R) and HF conditions were performed to compare the stress-strain behaviors, ductility, and post-formed hardness. The results have shown that the ductility for HFQ (R) condition was greater than that for the HF condition when forming temperature was below 400 degrees C. In addition, typical microstructural evolution, such as the low-melting phase of HFQ (R) and precipitation of HF, were identified using fracture morphology observations and used to explain ductility differences exhibited in these processes. Post-formed hardness resulting from HF with different initial alloy temper and forming conditions were determined and compared with those from HFQ (R). Severe reduction in hardness was found for HF using both high quench-sensitive alloy AA7075 and low quench-sensitive alloy AA6082. For the first time, the effects of a variety of influencing factors are investigated systematically, including heating rate, initial alloy, temperature and strain rate, on the high temperature deformation and post-formed strength of heat-treatable aluminium alloys, which contributes to the thorough understanding of the correlation between forming conditions and microstructural evolutions.