Densification, mechanical behaviors, and machining characteristics of 316L stainless steel in hybrid additive/subtractive manufacturing

摘要

Directed energy deposition (DED) is capable of manufacturing high-density and complex metal components, whereas traditional machining methods are limited in these regards. Nevertheless, the fabrication of parts with DED that have accurate dimensions and geometries as well as acceptable surface states is a concern, as these factors are inferior to those of traditionally machined components. Therefore, the application of parts fabricated with DED is restricted. Thus, the hybrid additive/subtractive manufacturing (HASM) method has been exploited to comprehensively utilize the advantages of both. In this paper, the HASM method was used to fabricate bulk parts with four different scanning strategies (alternating the orientation of subsequent layers by 0 degrees, 45 degrees, and 90 degrees and island scanning are referred to as an X-scan, a Rot-scan, an XY-scan, and an Island-scan, respectively) followed by subtractive milling to gain a smooth surface with a determined thickness for the next scanning and deposition period until the parts were completely finished. The influence of the scanning strategy on the densification level and mechanical behavior of the specimens fabricated with HASM was studied. The results show that the specimens fabricated with the 7 x 7 mm(2) island scan with short scan vector lengths showed a higher densification than the specimens fabricated using long scan vector lengths (the three methods mentioned above). Finally, to obtain a fine surface finish, the influence of the feed per tooth (f(z)) on the surface quality of a 316L stainless steel during the milling process that occurs during the HASM process was also investigated. The result shows a f(z) of 0.25 mm yielding the minimum surface roughness value among the samples observed herein, which implies that the surface quality was better than that of the other studied conditions.