首页> 外文期刊>Physics of fluids >Experimental and analytical investigation into lift prediction on large trailing edge flaps
【24h】

Experimental and analytical investigation into lift prediction on large trailing edge flaps

机译:大型后缘襟翼升力预测的实验与分析研究

获取原文
获取原文并翻译 | 示例
       

摘要

The present work aims to demonstrate the relationship between circulation production and force production on rapidly maneuvering wings using experimental measurements and two forms of low order modeling: an empirical model based on Lamb's point vortex impulse theory and an analytical model stemming from classical airfoil theory. Experiments were performed on a 50%-chord trailing-edge flap deflecting with a linear motion profile. Both flap-down (0 degrees - delta(f)) and flap-up (delta(f) - 0 degrees) motions were examined, where delta(f) = 20 degrees or 40 degrees. All cases were run at a Reynolds number of R-e similar to O(10(4)), corresponding to convective times on the order of the free stream or faster, with the fore element of the wing fixed at zero incidence. Time-resolved circulation measurements confirmed that bound circulation on the wing equated to circulation shed into the wake from the trailing edge for the duration of flap deflection. A two-vortex model matched well with the experimental results, regardless of whether the plate experienced fully attached or massively separated flow. An analytical model based only on flap kinematics showed an equivalence between its time-dependent quantities proportional to the motion rate ((delta) over dot, (delta) over double dot) and those proportional to the circulation rate (Gamma)over dot in the empirical model. Agreement between force measurements and both low order models emphasizes the need for future investigation into the direct relationship between force and circulation production.
机译:本工作的目的是展示使用实验测量和两种形式低阶建模的迅速机动翅膀循环生产和力生产的关系:基于羔羊的点涡冲动理论和分析模型,从古典翼理论所产生的经验模型。实验是在50%-chord尾缘襟翼具有线性运动轮廓偏转进行。两个翼片向下(0度 - 三角(F))和翼片式(△(F) - 0度)进行了检查的运动,其中,δ(F)= 20度或40度。所有情况下,在R-é类似于O(10(4))的雷诺数运行,对应于对流倍自由流的或更快的数量级上,具有固定在零入射角机翼的前部元件。时间分辨循环测试证实,对等同于循环棚成从襟翼偏转的持续时间后缘之后的机翼绑定循环。一种双涡流模型与实验结果匹配良好,无论是否板经历完全附着或大量分离流。仅基于盖运动的分析模型表明其依赖于时间的量成正比的运动速率((增量)超过点,(增量)超过双点)和那些正比于循环速率(伽玛)过点在之间的等价经验模型。力测量和两个低阶模型之间的协议强调了未来的调查力量和循环生产之间的直接关系的需要。

著录项

  • 来源
    《Physics of fluids》 |2019年第1期|共12页
  • 作者单位

    Univ Maryland Dept Aerosp Engn College Pk MD 20740 USA;

    Air Force Res Lab Wright Patterson AFB OH 45433 USA;

    Univ Maryland Dept Aerosp Engn College Pk MD 20740 USA;

  • 收录信息
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类 流体力学;
  • 关键词

  • 入库时间 2022-08-19 18:20:43

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号