Highly conductive copper nano/ microparticles ink via flash light sintering for printed electronics

摘要

In this study, the size effect of copper particles on the flash light sintering of copper (Cu) ink was investigated using Cu nanoparticles (20–50 nm diameter) and microparticles (2 μm diameter). Also, the mixed Cu nano-/micro-inks were fabricated, and the synergetic effects between the Cu nano-ink and micro-ink on flash light sintering were assessed. The ratio of nanoparticles to microparticles in Cu ink and the several flash light irradiation conditions (irradiation energy density, pulse number, on-time, and off-time) were optimized to obtain high conductivity of Cu films. In order to precisely monitor the milliseconds-long flash light sintering process, in situ monitoring of electrical resistance and temperature changes of Cu films was conducted during the flash light irradiation using a real-time Wheatstone bridge electrical circuit, thermocouplebased circuit, and a high-rate data acquisition system. Also, several microscopic and spectroscopic characterization techniques such as scanning electron microscopy, x-ray diffraction, x-ray photoelectron spectroscopy, and Fourier transform infrared spectroscopy were used to characterize the flash light sintered Cu nano-/micro-films. In addition, the sheet resistance of Cu film was measured using a four-point probe method. This work revealed that the optimal ratio of nanoparticles to microparticles is 50:50 wt%, and the optimally fabricated and flash light sintered Cu nano-/micro-ink films have the lowest resistivity (80 μΩ cm) among nanoink, micro-ink, or nano-micro mixed films.