...
首页> 外文期刊>Chemical Engineering Science >Mechanisms of hydrolysis in a transverse jet zinc aerosol reactor
【24h】

Mechanisms of hydrolysis in a transverse jet zinc aerosol reactor

机译:横向喷射锌气溶胶反应器中的水解机理

获取原文
获取原文并翻译 | 示例
           

摘要

The mechanisms of hydrolysis of zinc particles formed and entrained in a reacting gas flow were explored. Experiments were carried out in a transverse jet reactor designed for nucleation of Zn nanoparticles via a rapid quench followed by reaction at temperatures from 418 to 713 K. The aerosol particles were collected on a filter and characterized via X-ray diffraction and scanning electron microscopy. Even for quench rates as high as 10(4) K/s, nucleation of Zn vapor was incomplete. With a quench of Ar at temperatures less than the saturation temperature of Zn, 1 to 3 mu m hour-glass shaped hexagonal Zn particles were formed, consistent with formation via 2-D layer by layer by condensation and subsequent evaporation. Above the saturation temperature, Zn nanowires were formed from the vapor phase on the filter surface. With a steam quench, particles remained hexagonal but were generally smaller, from 300 nm to 1 mu m across the hexagonal face. Above 573 K, a shell of ZnO impeded evaporation of particles. Overall conversion of Zn to ZnO was dominated by the heterogeneous hydrolysis of Zn vapor, not hydrolysis of Zn particles. These results shed light on the mechanisms of particle growth and hydrolysis in Zn aerosol reactors. In particular, the finding that hydrolysis is dominated by a heterogeneous reaction between Zn(v) and steam is of critical importance to developing better approaches to react the Zn with steam, supporting prior work that shows that the heterogeneous vapor phase reaction is kinetically favored over the diffusion limited conversion of solid or liquid Zn particles. (C) 2014 Elsevier Ltd. All rights reserved.
机译:探索了形成和夹带在反应气流中的锌颗粒的水解机理。在设计用于通过快速骤冷使Zn纳米颗粒成核,然后在418至713 K的温度下反应的横向喷射反应器中进行实验。将气溶胶颗粒收集在过滤器上,并通过X射线衍射和扫描电子显微镜进行表征。即使淬火速度高达10(4)K / s,Zn蒸气的成核作用仍不完全。在低于Zn的饱和温度的温度下用Ar淬火,形成了1至3μm的沙漏形的六边形Zn锌颗粒,这与通过冷凝和随后的蒸发逐层形成的情况相一致。高于饱和温度,在过滤器表面上由气相形成Zn纳米线。通过蒸汽骤冷,颗粒保持六边形,但通常较小,横跨六边形表面在300 nm至1μm之间。高于573 K时,ZnO壳会阻止颗粒蒸发。 Zn到ZnO的总转化主要由Zn蒸气的非均相水解而不是Zn颗粒的水解决定。这些结果揭示了锌气溶胶反应器中颗粒生长和水解的机理。特别地,发现水解作用主要由Zn(v)与蒸汽之间的异质反应决定,这对于开发更好的方法使Zn与蒸汽反应至关重要,这支持先前的研究表明,异质气相反应在动力学上优于固态或液态锌颗粒的扩散受限转化。 (C)2014 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号