...
首页> 外文期刊>Colloids and Surfaces, A. Physicochemical and Engineering Aspects >The effect of the ionic strength on the rheological behavior of hydrophobically modified polyacrylamide aqueous solutions mixed with sodium dodecyl sulfate (SDS) or cetyltrimethylammonium p-toluenesulfonate (CTAT)
【24h】

The effect of the ionic strength on the rheological behavior of hydrophobically modified polyacrylamide aqueous solutions mixed with sodium dodecyl sulfate (SDS) or cetyltrimethylammonium p-toluenesulfonate (CTAT)

机译:离子强度对与十二烷基硫酸钠(SDS)或对甲苯磺酸十六烷基三甲基铵(CTAT)混合的疏水改性聚丙烯酰胺水溶液的流变行为的影响

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Two hydrophobically modified polyacrylamides (HMPAMs) with different molar contents of t-octylacrylamide as hydrophobic comonomer (1 and 1.5%molar) were synthesized by aqueous micellar copolymerization in water. The molecular structure was characterized in detail by light scattering and viscometric measurements using automatic continuous mixing(ACM) techniques in dilute solution. There was no significant difference between the weight average molecular weight (M-w) of homopolyacrylamide and the copolymers. The elucidation of polymer microstructure by H-1 NMR showed I hat the hydrophobe content in the polymer backbone is almost the same as the hydrophobe content in the feed. This study reveals that branched t-octyl alkyl chains are not hydrophobic enough to induce significant associating properties, but can exhibit strongly magnified thickening properties in the presence of surfactant. The effect of NaCl addition to the solutions of the prepared HMPAMs was also explored as well as their interactions with sodium dodecyl sulfate (SDS) or cetyltrimethylammonium p-toluenesulfonate (CTAT). A direct comparison of the influence of spherical surfactant micelles and worm-like micelles on the rheological properties of the same polymer samples was made. For a given HMPAM copolymer at a fixed concentration in deionized water, the Solutions zero-shear viscosities tend to increase upon adding surfactant, then they go through a maximum and then decrease (in the case of CTAT the viscosity after the maximum tends to slowly increase with CTAT concentration). These well known effects are due to the hydrophobic interactions between HMPAM and SDS or CTAT. The maximum viscosity occurs in HMPAM/SDS deionized water solutions. However, we demonstrate that by the addition of salt, the HMPAM/CTAT solutions can exhibit much higher viscosities (two orders of magnitude) than HMPAM/SDS solutions at low CTAT concentrations and high ionic strengths (larger than 1.5 M NaCl). This pronounced increased in viscosity is attributed to the growth of the CTAT worm-like micelles as the ionic strength increase,3, which can interact with the hydrophobic groups present in the HMPAMs and can form an entangled interacting network in solution.
机译:通过在水中胶束共聚反应,合成了两种不同的叔辛基丙烯酰胺摩尔含量的疏水改性聚丙烯酰胺(HMPAMs)作为疏水性共聚单体(分别为1和1.5%摩尔)。通过在稀溶液中使用自动连续混合(ACM)技术进行光散射和粘度测量来详细表征分子结构。均聚丙烯酰胺和共聚物的重均分子量(M-w)之间没有显着差异。通过H-1 NMR对聚合物微观结构的阐明表明,在聚合物主链中的疏水物含量几乎与进料中的疏水物含量相同。这项研究表明,支链的叔辛基烷基链的疏水性不足以诱导显着的缔合特性,但是在存在表面活性剂的情况下却表现出强烈放大的增稠特性。还研究了向制备的HMPAM溶液中添加NaCl的效果,以及它们与十二烷基硫酸钠(SDS)或十六烷基三甲基铵对甲苯磺酸盐(CTAT)的相互作用。直接比较了球形表面活性剂胶束和蠕虫状胶束对相同聚合物样品流变性的影响。对于去离子水中固定浓度的给定HMPAM共聚物,溶液的零剪切粘度在添加表面活性剂后趋于增加,然后经历最大值,然后降低(对于CTAT,最大值后的粘度趋于缓慢增加) CTAT浓度)。这些众所周知的效果归因于HMPAM与SDS或CTAT之间的疏水相互作用。最大粘度出现在HMPAM / SDS去离子水溶液中。但是,我们证明,通过添加盐,在低CTAT浓度和高离子强度(大于1.5 M NaCl)下,HMPAM / CTAT溶液的粘度(两个数量级)要比HMPAM / SDS溶液高得多。粘度的显着增加归因于离子强度的增加3,CTAT蠕虫状胶束的生长,3可以与HMPAM中存在的疏水基团相互作用,并可以在溶液中形成纠缠的相互作用网络。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号