...
首页> 外文期刊>Journal of the European Ceramic Society >Ferroelastic deformation of La_(0.58)Sr_(0.4)Co_(0.2)Fe_(0.8)O_(3-δ) under uniaxial compressive loading
【24h】

Ferroelastic deformation of La_(0.58)Sr_(0.4)Co_(0.2)Fe_(0.8)O_(3-δ) under uniaxial compressive loading

机译:单轴压缩载荷下La_(0.58)Sr_(0.4)Co_(0.2)Fe_(0.8)O_(3-δ)的铁弹性变形

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

The mechanical deformation of lanthanum strontium cobalt ferrite under uniaxial compression was investigated at various temperatures. The material revealed a rather complex mechanical behaviour related to its ferroelasticity and stress-strain curves obtained in the 1 st and 2nd loading cycles were completely different. A distinctive ferroelastic creep was observed at 293 K whilst typical ferroelastic stress-strain curves were obtained in the temperature range from 473 K to 873 K. At 1073 K, high-temperature creep deformation was observed instead of the ferroelastic deformation. The apparent Young's modulus was evaluated in various ways;;the modulus determined from the last unloading curve ranged between 85 and 120 GPa. The obtained critical stress monotonically decreases from about 80MPa to zero with increasing temperature, corresponding to the behaviour of the remnant strain. The presented results indicate that the importance of an appropriate consideration of the loading history in the practical application of these ferroelastic materials.
机译:研究了镧锶锶铁氧体在不同温度下的单轴压缩力学变形。该材料显示出与其铁弹性有关的相当复杂的机械行为,在第一个和第二个加载循环中获得的应力-应变曲线完全不同。在293 K处观察到了明显的铁弹性蠕变,而在473 K至873 K的温度范围内获得了典型的铁弹性应力-应变曲线。在1073 K处观察到了高温蠕变变形而不是铁弹性变形。表观杨氏模量以各种方式评估;根据最后的卸载曲线确定的模量在85至120 GPa之间。随着温度的升高,获得的临界应力从约80MPa单调降低至零,这与残余应变的行为相对应。给出的结果表明在这些铁弹性材料的实际应用中适当考虑载荷历史的重要性。

著录项

相似文献

  • 外文文献
  • 中文文献
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号