...
首页> 外文期刊>Journal of the European Ceramic Society >In-situ synthesis and properties of cordierite-bonded porous SiC membrane supports using diatomite as silicon source
【24h】

In-situ synthesis and properties of cordierite-bonded porous SiC membrane supports using diatomite as silicon source

机译:以硅藻土为硅源的堇青石键合多孔SiC膜载体的原位合成及性能

获取原文
获取原文并翻译 | 示例

摘要

Cordierite-bonded porous SiC membrane supports with diatomite as silicon source were prepared in air at 1150-1400 degrees C via reaction bonding technique. The phase composition, microstructure, flexural strength, open porosity, pore size distribution as well as dielectric properties of membrane supports were investigated as a function of the mass ratio of different starting materials, sintering temperature, graphite content and holding time. It was found that the diatomite addition strongly promoted the phase transformation towards cordierite, meanwhile, due to the enhancement of necks at the contacting pionts growth by the additions of diatomite (5.17 wt%), a high three-point flexural strength of 49.19 MPa was achieved at an open porosity of 37.72% sintered at 1250 degrees C for 3 h. Meanwhile, the cordierite structure can incorporate of diatomite (like Fe2O3) by solid solution formation, which can highly enhance on the electrical properties of cordierite-bonded SiC porous ceramics. (C) 2016 Published by Elsevier Ltd.
机译:通过反应结合技术在1150-1400℃的空气中制备了以硅藻土为硅源的堇青石结合多孔SiC膜载体。研究了膜载体的相组成,微观结构,抗弯强度,开孔率,孔径分布以及介电性能,它是不同起始原料的质量比,烧结温度,石墨含量和保持时间的函数。发现硅藻土的添加强烈促进了向堇青石的相变,同时,由于通过添加硅藻土(5.17 wt%)增强了接触点生长时的颈部,三点弯曲强度达到了49.19 MPa。在37.72%的开孔率下,在1250摄氏度下烧结3小时,获得了3。同时,堇青石结构可以通过固溶体形成而结合硅藻土(如Fe 2 O 3),这可以大大提高堇青石结合的SiC多孔陶瓷的电性能。 (C)2016由Elsevier Ltd.出版

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号