...
首页> 外文期刊>Journal of Semiconductors >A fast transient response low dropout regulator with current control methodology
【24h】

A fast transient response low dropout regulator with current control methodology

机译:具有电流控制方法的快速瞬态响应低压差稳压器

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

A transient performance optimized CCL-LDO regulator is proposed. In the CCL-LDO, the control method of the charge pump phase-locked loop is adopted. A current control loop has the feedback signal and reference current to be compared, and then a loop filter generates the gate voltage of the power MOSFET by in-tegrating the error current. The CCL-LDO has the optimized damping coefficient and natural resonant frequency, while its output voltage can be sub- 1-V and is not restricted by the reference voltage. With a 1μF decoupling capacitor, the experimental results based on a 0.13 μm CMOS process show that the output voltage is 1.0 V; when the workload changes from 100 μA to 100 mA transiently, the stable dropout is 4.25 mV, the settling time is 8.2 As and the undershoot is 5.11 mV; when the workload changes from 100 mA to 100 μA transiently, the stable dropout is 4.25 my, the settling time is 23.3 μs and the overshoot is 6.21 mV. The PSBR value is more than —95 dB. Most of the attributes of the CCL-LDO are improved rapidly with a FOM value of 0.0097.
机译:提出了一种瞬态性能优化的CCL-LDO稳压器。在CCL-LDO中,采用了电荷泵锁相环的控制方法。电流控制环路具有要比较的反馈信号和参考电流,然后环路滤波器通过对误差电流进行积分来生成功率MOSFET的栅极电压。 CCL-LDO具有优化的阻尼系数和自然谐振频率,而其输出电压可低于1V,不受参考电压的限制。在使用1μF去耦电容器的情况下,基于0.13μmCMOS工艺的实验结果表明,输出电压为1.0V。当工作负载从100μA瞬变到100 mA时,稳定的压差为4.25 mV,建立时间为8.2 As,下冲为5.11 mV;当工作负载从100 mA瞬变到100μA时,稳定的压差为4.25 my,建立时间为23.3μs,过冲为6.21 mV。 PSBR值大于-95 dB。 FCL值为0.0097,CCL-LDO的大多数属性都得到了快速改善。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号