首页> 外文期刊>Journal of orthopaedic science : >Effect of periacetabular osteotomy for acetabular dysplasia clarified by three-dimensional finite element analysis.
【24h】

Effect of periacetabular osteotomy for acetabular dysplasia clarified by three-dimensional finite element analysis.

机译:三维有限元分析明确了髋臼周围截骨术对髋臼发育不良的影响。

获取原文
获取原文并翻译 | 示例
           

摘要

BACKGROUND: Finite element analysis (FEA) has been applied for the biomechanical analysis of acetabular dysplasia, but not for biomechanical studies of periacetabular osteotomy (PAO) or those performing analysis taking into consideration the severity of acetabular dysplasia. This study aimed to perform biomechanical evaluation of changes in stress distribution following PAO and to determine the effect of the severity of developmental dysplasia of the hip (DDH) using three-dimensional FEA. METHODS: A normal model was designed with a 25 degrees center-edge (CE) angle and a 25 degrees vertical-center-anterior margin (VCA) angle. DDH models were designed with CE and VCA angles each of 10, 0, or -10 degrees . Post-PAO models were created by separating each DDH model and rotating the acetabular bone fragment in the anterolateral direction so that the femoral head was covered by the acetabular bone fragment, with CE and VCA angles each at 25 degrees . RESULTS: Compared to the normal hip joint model, the DDH models showed stress concentration in the acetabular edge and contacting femoral head, and higher stress values; stress increased with decreasing CE and VCA angles. Compared to the DDH models, the post-PAO models showed near-normal patterns of stress distribution in the acetabulum and femoral head, with stress concentration areas shifted from the lateral to medial sides. Stress dispersion was especially apparent in the severe acetabular dysplasia models. PAO provided greater decreases in the maximum values of von Mises stress in the load-bearing area of the acetabulum and femoral head when applied to the DDH models of higher degrees of severity, although the values increased with increasing severity of DDH. CONCLUSIONS: PAO is expected to provide biomechanical improvement of the hip joint and to be particularly effective in patients with severe preoperative DDH, although the results also suggested a limitation in the applicability of PAO for these patients.
机译:背景:有限元分析(FEA)已用于髋臼发育不良的生物力学分析,但未用于髋臼周围截骨术(PAO)或进行考虑髋臼发育不良严重程度的分析的生物力学研究。这项研究旨在进行生物力学评估PAO后应力分布的变化,并使用三维有限元分析确定髋关节发育不良(DDH)严重程度的影响。方法:设计一个正常模型,其中心边缘(CE)角度为25度,垂直中心前缘(VCA)角度为25度。 DDH模型的CE和VCA角度分别为10度,0度或-10度。通过分离每个DDH模型并沿前外侧方向旋转髋臼骨碎片以使股骨头被髋臼骨碎片覆盖,CE和VCA角度均为25度,从而创建了PAO后模型。结果:与正常髋关节模型相比,DDH模型显示髋臼边缘和接触股骨头的应力集中,应力值较高。应力随着CE和VCA角度的减小而增加。与DDH模型相比,PAO后模型显示髋臼和股骨头的应力分布接近正常模式,应力集中区域从外侧向内侧移动。在严重的髋臼发育不良模型中,应力分散尤其明显。当将PAO应用于严重程度较高的DDH模型时,在髋臼和股骨头的承重区域中,von Mises应力最大值的减小幅度更大,尽管该值随DDH严重程度的增加而增加。结论:PAO有望改善髋关节的生物力学性能,对重度术前DDH患者尤其有效,尽管结果也表明PAO在这些患者中的适用性受到限制。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号