Dynamic Rheological Behavior of HDPE/UHMWPE Blends

摘要

The rheological behaviors of high-density polyethylene (HDPE)/ultra-high molecular weight polyethylene (UHMWPE) blends prepared by melt blending and solution blending were studied. The results showed that the rheological parameters (G′, G ~″, and η*) of both types of blends increased gradually with increasing fraction of UHMWPE, while the tanδ decreased correspondingly. Comparing blends with the same UHMWPE content, all G′, G ~″, and η* values of solution blends were higher, and the tanδ of the solution blends were remarkably lower than those of the melt blends. Combined with the scanning electron microscopy (SEM) observations, it was proved that, because of its very high melt viscosity, the UHMWPE chain is difficult to diffuse and be distributed well in the HDPE matrix by melt blending, resulting in a two-phase-like morphology. On the other hand, the blends prepared by the solution blending showed a homogeneous distribution of UHMWPE in the HDPE matrix. In addition, the state of aggregation of the UHMWPE in the HDPE matrix can be distinguished well by time-temperature superposition (TTS) curves; i.e., the two-phase-like morphology in the melt blends can be detected by the failure of TTS in the high-frequency range, which cannot be reflected by Cole-Cole plots and Han curves.