Machining of Al/SiC particulate metal-matrix composites Part 1: Tool performance

摘要

Despite the superior mechanical and thermal properties of particulate metal-matrix composites, their poor machinability has been the main deterrent to their substitution for metal parts. The hard abrasive reinforcement phase causes rapid tool wear during machining and, consequently, high machining costs. A series of dry high-speed turning tests were performed to select the optimum tool material, tool geometry and cutting parameters for the turning of 20%SiC/Al metal-matrix composites. The resultsindicate that polycrystalline diamond tools (PCD) provide satisfactory tool life compared to alumina and coated-carbide tools, where the latter tools suffered from excessive edge chipping and crater wear during the machining of the metal-matrix compositeunder study. Furthermore, the cost of PCD tools could be justified by using dry cutting at feed rates as high as 0.45 mm rev{sup}-1, cutting speeds of 894 m min{sup}-1 and a depth of cut of 1.5 mm. With these cutting parameters, the relatively smallbuilt-up edge formed on the tool protects it from further wear by abrasion and micro-cutting. Polycrystalline tools with zero rake angle and large tool nose radii are recommended for the roughing operations.